Questions Flashcards
“Open the bonnet, identify where you would check the engine oil level and tell me how you would check that the engine has sufficient oil”
Open the bonnet identify dipstick/ oil level indicator, described oil level check against minimum/maximum markers
Open the bonnet identify the windscreen washer reservoir and tell me how you would check the windscreen washer level
Open the bonnet, identify reservoir and explain how to check level
Open the bonnet, identify where you would check the engine coolant level and tell me how you would check that the engine has the correct level
Open the bonnet identify high/low level markings on header tank where fitted or radiator filler cap, and describe how to top up to correct level. Radiators are only opened with a cold engine
Open the bonnet, show me how you would check that you have a safe level of hydraulic brake fluid
Open the bonnet, identify brake fluid reservoir and explain how to check level
Show me how you would check the parking brake for excessive wear
Demonstrate by applying parking brake so that when it is fully applied it secures the car and is not at the end of its working travel. Keep your foot on the footbrake.
Show me how you would check that the horn is working
Sound horn by using appropriate device (off road only)
Show me how you would clean the windscreen using washers and wipers
Operate control to wash and wipe windscreen
Show me/explain how you would check that the power assisted steering is working before starting a journey
If steering becomes heavy the system may not be working properly. After starting the engine two simple check can be made. Gentle pressure on the steering wheel should result in a slight but noticeable movement as the system begins to operate. Or, turn the steering wheel as you move off, you will get an immediate indication that the power assistance is working
Show me how you would check that the direction indicators or hazard warning lights are working
Apply the indicators/hazard warning switch and check all indicators
Show me how you would check that the brakes are working correctly before starting a journey
Brakes should feel not spongy or slack. Brakes should be tested as you set off. Vehicle should not pull to one side when you brake
Tell me how you would check that the headlights and tail lights are working
Operate switch and then walk around vehicle
Tell me where you find the information for the recommended tyre pressure for this car and how tyre pressures should be checked
Manufacturers guide, use a reliable pressure gauge, check and adjust pressures when tyres are cold. Don’t forget spare tyre, remember to refit valve caps
Tell me how you would check the tyres to ensure that they have sufficient tread depth and that their general condition is safe to use on the road
No cuts or bulges. 1.6mm of tread depth across the central 3/4 of the type and around the entire outer circumference. Remember your spare tyre
Show me how you would switch from dipped headlight to main beam. Explain how you would know the main beam is on whilst inside your car
Operate switch and check for main beam warning light
Show me how you would set the demister controls to clear both front and rear windscreens effectively
Set relevant controls which include: fan, temperature, air direction and source, plus heated seat controls
