Pre-start inspections

Question 1

Below list 8 inspection you would carry out on a pre-start-up check?

Answer 1

1. Data plate
2. controls
3. overhead guard
4. tyres
5. rams
6. mast
7. forks
8. load backrest

Question 2

explain what action you would take if you locate a defect or found a fault with the data plate during an inspection of the forklift, provide 5 actions you would take

Answer 2

1. don’t use forklift
2. take key
3. tag forklift
4. tell boss
5. fill in log book

Question 3

during forklift operation explain some hazards that may be associated with bad weather conditions; provide 6 different weather conditions

Answer 3

1. snow
2. strong wind
3. wet/slippery conditions
4. fog
5. smoke
6. heat

Question 4

Why must you always ensure tyres which are filled with air always have correct pressure?

Answer 4

flat tyres could cause the forklift to tip over

Question 5

lift 4 reasons why it is important to inspect tyres during pre-operational inspections/

Answer 5

1. missing rubber
2. not worn down
3. wear is even
4. secured correctly to forklift

Question 6

if you were required to secure an attachment onto the forklift, where would you locate the correct information to do this?

Answer 6

manufactures instructions

Question 7

what affect would there be on the forklift capacity if you were to add an attachment (2 examples)

Answer 7

1. load capacity reduced

2. load centre distance could be increased