Practice Test 4 Flashcards
A type of port assigned to carry traffic from all the VLANs connected to a specific network switch is known as:
- Default gateway
- Trunk port
- Registered port
- Mirrored port
Trunk port
To allow traffic from multiple VLANs on a single communication link, frames from individual VLANs must be identified. The most common and preferred method, IEEE 802.1Q, adds a tag to the Ethernet frame header, labeling it as belonging to a certain VLAN.
- True
- False
True
To allow traffic from multiple VLANs on a single communication link, frames from individual VLANs must be identified. The most common and preferred method, IEEE 802.1Q, adds a tag to the Ethernet frame header, labeling it as belonging to a certain VLAN.
- Port mirroring
- VLAN tagging
- Fault-tolerant mode
- Port scanning
Port mirroring
Which of the protocols listed below provide protection against switching loops? (Select 2 answers)
- RTP
- SRTP
- RDP
- STP
- RSTP
STP
RSTP
A solution that allows to supply electricity over standard Ethernet cables is known as: (Select 2 answers)
- IEEE 802.3ab
- PoE
- Metro-Ethernet
- IEEE 802.3af
- PSTN
PoE
IEEE 802.3af
Which of the following standards implements PoE+?
- IEEE 802.1d
- IEEE 802.3at
- IEEE 802.1x
- IEEE 802.3ab
IEEE 802.3at
A lightly protected subnet consisting of publicly available servers placed on the outside of the company’s firewall is referred to as:
- VPN
- Extranet
- VLAN
- DMZ
DMZ
An Ethernet switch forwards LAN traffic from connected devices based on the information stored in:
- DNS table
- Routing table
- MAC address table
- Firmware
MAC address table
An Ethernet switch table containing IP-to-MAC address mappings is called:
- ARP table
- Routing table
- MAC address table
- DNS table
ARP table
Which of the answers listed below refers to a type of routing protocol that determines the best route for data packets based on the lowest number of hops?
- Hybrid
- Link-state
- Distance-vector
- Dynamic
Distance-vector
A type of routing protocol that calculates the best path between source and destination nodes based on a map of network connectivity between nodes is called:
- Dynamic
- Link-state
- Static
- Distance-vector
Link-state
A hybrid routing protocol combines the features of distance-vector and link-state routing protocols.
- True
- False
True
A manually-configured routing table entry is known as:
- Static route
- Dynamic route
- Hybrid route
- Default route
Static route
Automatic routing table update is a feature of:
- Static routing
- Route redistribution
- Dynamic routing
- Route aggregation
Dynamic routing
The term “Default route” refers to a “last resort” network path used by a router for forwarding all packets with destination addresses not listed in its routing table.
- True
- False
True
