PHASE III Flashcards
What is the height to top of fin of the P-8A?
42 ft 9 inches
the nose radome of the aircraft is primarily made up of what material?
fiberglass
what axis do the elevators control and what is it effect?
lateral axis and pitch
in reference to tires and wheel, what type of wheel assembly does the P-8A use?
dual wheel assembly
what type of engines does the P-8A use?
CFM56-7B
what type of power does the APU supply to the aircraft?
115 volts/400 hertz
what does IDG stand for?
Integrated drive generator
What does URASSI stand for?
Universal Aerial Refuel Receptacle Slipway Installation
The fuel tanks are divided into how many tank groups?
5
Each main tank has how many fuel boost pumps in it?
2 fuel boost pumps
NEA (Nitrogen Enriched Air) keeps the tanks at or below a ___ oxygen level through the entire design flight envelope?
9%
In reference to Air Conditioning Pressurization, what is the maximum allowable cabin altitude before aircraft pressurization is needed?
8,000 feet
where are the flight crew oxygen system cylinders located?
E/E compartment
What stages of the engine uses bleed air?
5th and 9th of the engine
what is the reservoir capacity of system A?
6.8 gallons
The hydraulic power transfer unit (PTU) system supplies alternative hydraulic pressure to the leading edge flaps and slats only?
T
The main auxiliary hydraulic system supply pressurized fluid to 10 different airplane systems, name 5 of them?
- both thrust reversers
- power transfer unit [PTU] motor
- landing gear extension and retraction
- nose wheel steering
- main gear brakes
- primary flight controls
- secondary flight controls
- air-to-air refueling
- weapons bay doors
- mechanism, also referred to as Annex B
What are the water and waste systems 3 subsystems?
- potable water
- air supply
- water disposal
the potable water system supplies water to what 2 areas of the P-8A?
- lavatory
- galley
how many dry bay fire suppresses are there throughout the P-8A?
59 suppressors