Phase 1's Flashcards
Rejected T.O. Before V1
- Thrust Levers - IDLE
- Wheel Brake - APPLY
- TR’s - APPLY
ENGINE FIRE – GROUND
1) Thrust Lever Idle
2) Engine Run Off
3) Disch Handle Pull
4) Disch Handle Turn
5) Disch Handle Turn
APU FIRE - IN FLIGHT
- APU Off
- APU DISCH Confirm & Pull
After 10 Sec and Fire Remains:
- APU DISCH TURN
After 60 Sec and Fire Remains:
- APU DISCH Handle Unlock
- APU DISCH Handle Turn
APU FIRE - GROUND
- APU Off
- APU DISCH Confirm & Pull
- APU DISCH TURN
- APU DISCH Handle Unlock
- APU DISCH Handle Turn
ENGINE FIRE - IN FLIGHT
1) Thrust Lever Confirm & Idle
2) ENGINE RUN Confirm & Off
3) DISCH Handle Confirm & Pull
After 10 Sec and Fire Remains:
4) DISCH Handle Turn
After 45 Sec and Fire Remains:
5) DISCH Handle Turn
POST-SHUTDOWN ENGINE TAIL PIPE FIRE
- ENGINE RUN Confirm & Off
Bleed air is available:
- Engine Start L(R) CRANK
Until ITT <150º or flame is out
- Emergency Evac Accomplish
DUAL ENGINE FLAMEOUT
- RAT Deploy
- Target Glide Speed Establish
60,000lbs. = 180 ———– 90,000lbs. = 220
LEFT (R) REVERSER UNLKD MESSAGE
- THRUST LEVER Confirm & Idle
- ENGINE RUN Confirm & Off
- Airspeed < 170
VISIBLE SMOKE OR FIRE
- O2 MASK Don & Set
- Crew Comms Establish
- Pack Control HIGH
- BLEED / AIR COND RECIRC OFF
- PRESSURIZATION AUTO/MAN MAN
- PRESSURIZATION MAN ALT UP
EMERGENCY DESCENT & CABIN ALT MESSAGE
- O2 MASK Don & 100%
- Crew Comms Establish
- PASS OXYGEN Override
- PASS SIGNS ON
- EMER LIGHTS ON
- Descent Initiate
- Thrust Levers Idle
- Flight Spoilers Deploy
EMERGENCY DESCENT (AUTO MODE)
- O2 MASK Don & 100%
- Crew Comms Establish
- PASS OXYGEN Override
- PASS SIGNS ON
- EMER LIGHTS ON
- Flight Spoilers Deploy
UNPLANNED DITCHING or FORCED LANDING
- DITCHING ON
EMERGENCY EVACUATION
PILOT:
- Parking Brake Set
- Evacuation Command
- GND LIFT DUMPING OFF
- Flight Spoiler Lever Retract
- L & R ENGINE RUN OFF
- APU OFF
- L, R, & APU DISCH Handles Pull
- Evacuation Initiate
- BATT MASTER OFF
COPILOT
- ATC Notify
- EMER DEPRESS ON
- EMER LTS ON
EMERGENCY POWER ONLY
- GEN 1,2,3,4 (one at a time) OFF/RESET
LOSS OF ALL DC POWER
(all display units blank)
- ELECT DC PWR, EMER OVRD OVRD