P-8A Flashcards

1
Q

When the OIL QUANTITY REPORT page shows ADD for the oil level, what action should be taken?

A

Initiate MAF.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
2
Q

The APU operator licensing program shall be managed by QA and administered by the NATOPS officer.

A

False

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
3
Q

The Command Officer may delegate the authority to sign APU authorizations as low as department heads.

A

False

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
4
Q

The APU continues to operate for approximately 60 seconds during it’s cool down cycle.

A

True.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
5
Q

One of the indications of an APU fire is the APU fire switch is illuminated.

A

True.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
6
Q

How many indications are there for APU fire?

A

More than 6.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
7
Q

If extended APU operation or prior to engine start, which fuel boost pump should be turned on?

A

Left center, if center tank quantity is over 1000 pounds.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
8
Q

The APU can be started or shutdown during refueling operations.

A

True.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
9
Q

If the APU DET INOP light fails to illuminate DO NOT OPERATE THE APU.

A

True.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
10
Q

The APU fire detection system is powered by the hot battery bus.

A

False.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
11
Q

The Center tank fuel pump switches should be positioned to ON only if the fuel quantity in the center tank exceeds 1000 pounds.

A

True.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
12
Q

An APU maintenance problem exists when what light is illuminated?

A

BLUE MAINT LIGHT.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
13
Q

During APU operation, fuel is automatically heated to prevent icing.

A

False

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
14
Q

Rotating the APU fire switch in either direction mechanically fires the squib, discharging the extinguishing agent into the APU.

A

True.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
15
Q

If the start fails or the APU RUNNING light fails to illuminate by the end of the start cycle, what has just occurred?

A

A system failure has occurred and the fault light illuminates.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
16
Q

A DC operated boost pump is installed to ensure positive fuel pressure…

A

… To the APU fuel control during start and operation and automatically when the APU fuel control unit senses low fuel pressure.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
17
Q

Air for the APU cooling comes from where?

A

Air inlet.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
18
Q

The MO must recommend an unqualified individual prior to commencement of APU turn-up training.

A

True.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
19
Q

The first step of the emergency procedures of an APU fire is to pull and rotate the APU fire switch to the top for one second.

A

True.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
20
Q

If you get an illuminated over speed light, the light will remain illuminated for _______ when the APU switch is placed off.

A

5 minutes.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
21
Q

If the APU fire warning light is not illuminated, but a fire indication exists or a fire is reported in or near the APU?

A

Press the APU fire switch lock release button, pull the APU fire switch, rotate the APU fire switch to the top until APU bottle discharge light illuminates.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
22
Q

If you do no preserve the APU, at a minimum it is recommended to do an APU operation……

A

Once every 7 days.

23
Q

Operate APU for ONE full minute before using it as a bleed air source.

A

True

24
Q

The APU fire control huandle in the right wheel well normal position is….

A

Up.

25
Q

The EGT indicator remains powered for ______ after shutdown.

A

5 minutes.

26
Q

It is required to immediately shutdown the APU if a fuel spill occurs.

A

True.

27
Q

When external power is selected OFF, the APU generator automatically assumes the entire electrical load.

A

True.

28
Q

What is the maximum start cycle for the start power unit (SPU) and the start converter unit (SCU)?

A

3 starts, one right after the other, followed by a 15 minute cool down period.

29
Q

How many APU fire extinguishing bottle(s) are on the aircraft?

A

1

30
Q

When applying external power of APU generator power, the standby hydraulic pump can operate for approximately _____ and may move the rudder and/or thrust reversers.

A

4 seconds.

31
Q

What is the APU oil specification?

A

Mobile Jet Oil 2

32
Q

Pulling the APU fire switch up arms the APU extinguisher circuit and closes the fuel shutoff valve.

A

True.

33
Q

During the APU operation, fluid coming from the forward drain of the APU is from….

A

The aux tank.

34
Q

What automatically controls APU speed through the Electronic Fuel Control?

A

ECU

35
Q

Moving the battery switch to off will NOT shut down the APU in flight or on the ground.

A

False.

36
Q

The APU oil quantity may be checked by what method?

A

APU bite test, oil sight gauge with APU on/off, APU status page on the CDU.

37
Q

The APU ground control panel is located where?

A

Right main wheel well.

38
Q

Do not try an APU start if there is ice around the hinged flap of the vortex generator because….

A

The motor for the inlet door actuator can be damaged.

39
Q

While performing an APU fire warning system test on the ground, the remote APU fire warning does not sound.

A

False.

40
Q

During the APU start cycle, the APU EGT indication may fluctuate from ___ to ___ prior to normal EGT rise.

A

0-1100

41
Q

The APU has a single fire detection loop.

A

True.

42
Q

What is the total oil quantity in the APU at full?

A

5.7 quarts.

43
Q

APU fire detection consists of both the APU fire detection powered by the battery bus and the APU fire extinguishing powered by the hot battery bus.

A

True.

44
Q

Where does the electrical power to start the APU come from?

A

Two engine integrated drive generators (IDGs) that supply 3 phase, 115 V, 400 cycle AC.

45
Q

If the AC and DC fuel pumps are not operating, fuel suction is fed from where?

A

Tank no. 1

46
Q

What starts the APU?

A

Aircraft AC system and aircraft main battery.

47
Q

The APU fire switch unlocks when….

A

The APU fire light illuminates.

48
Q

If fluid is leaking from the APU compartment, what is the fluid.

A

Fuel.

49
Q

What takes control of power when external power is shut off?

A

The battery and AC generator.

50
Q

When performing a standby power check, your AC/DC voltmeter should read….

A

115 VAC/24 VDC

51
Q

What fuel does the P-8A require?

A

Jet-2… Not Milspec or JP-5.

52
Q

When the oil quantity report page shows add for the oil level, you must add oil to the APU within how many hours?

A

30-50 hours.

53
Q

Prior to APU start, which fuel boost pump should be turned on?

A

Left center AC fuel tank.

54
Q

The ECU monitors and controls the APU. Automatic shutdown protection is provided for 6 conditions and system faults

A

True