open Book Flashcards
In light icing conditions, the warm up time for the system to become fully functional is 10-30 min. The operator must turn on the heaters via the gimbal video menu. The heaters shut off automatically after ___ minutes?
20
What is the recommended action for an Alarm 6.14 on the asx-4?
If calibration procedure fails, retry calibration. If a second failure occurs adjust setup from default to high and retry.
After engine starts and re-initializing of AIMs system, place the AIMs mode switch to the stow position. I R cooling will not be performed if the switch remains in
Turret Disable
What AVT mode is used with targets displaying consistent white or black areas?
Centroid
EOW can focus on objects that are ____ ft and further from the ATU.
4 ft
The two point calibration is exactly the same as the one point calibration but will utilize as special clear lens to further calibrate the sensor.
False
When outside air temp is in excess of ____ degrees, restrict ground operations to one hour power on, then 4 hours power off.
95 F
What message will be displayed with a 4.17 alarm on asx-4?
Minor roll lock failure
Under the aims parameter tableau data, how often does the radar horizon update?
60 sec
What’s the max airspeed for extending and retracting the turret?
350 KIAS
Images may also be captured on the AIC drive, these images must be spooled to the ____ drive for manipulation and transmission.
IP drive
GPS functions are available with AIS (true/false)
False.
If the AIS program is not available, what will be available to the operator?
A warning in a pop up window
With ALR 95: the R drive will be demapped inside the RDP (sp-160) and the system will not be able to connect to the rdss or adss DTIU through the Ethernet. The system will be unusable, and this condition is not recoverable. What causes this?
Canceling or closing the restoring network connections window.
The _____ provides displays and controls for the threat warning, ESM/SEI capabilities for acquisition, identification, surveillance, tracking and precision analysis of signals of interest.
HMI (human machine interface)
Ensure no more than five windows are open at one time. It could cause a software crash. This statement is a ______.
Note.
Do not remove the mo disk or power down the rdss with ESM /SEI system energized. Software corruption may occur to the ____and/or_______.
RDP/MO disk
The tuner for ALR 95 covers the ____ to ______ freq range.
.5-18
The RDP requires approx ______ min to warm up. Bit statuses are not valid until completion of warm up period.
10 min
Power must be applied to the ____ and _____ loaded prior to the Tacco power control SEI/Off switch being set to the SEI position or software corruption may occur to the RDP or MO disk.
RDSS/MO Disk
What provides ARINC 575 Nav data directly to the SP 160
INS 2