NAV Flashcards
Which of the following methods can be used to connect to the NAV internal webpage? (select all that apply)
[ ] USB configuration cable
[ ] Ethernet Cable
[ ] ping command
[ ] loop thru
[ x] USB configuration cable
[ x] Ethernet Cable
[ ] ping command
[ ] loop thru
True or False: Pure 3’s ISS - Intelligent Selective Streaming leverages low motion content to achieve extremely low bitrates while maintaining visually lossless performance.
True
The Navigator has the ability to configure endpoints with a device name, location, IP address, and which of the following? (select all that apply)
[ ] EDID assignment
[ ] Encoder audio stream type
[ ] Encoder Bitrate adjustments
[ ] Deivce Tags
[ ] All of the above
[ ] EDID assignment
[ ] Encoder audio stream type
[ ] Encoder Bitrate adjustments
[ ] Deivce Tags
[x ] All of the above
The ID toggle button located on the front NAV endpoints and on the internal webpage serves the following functions?
[ ] Toggles LED to identify device
[ ] Device information will be presented on the connected display devices.
[ ] ID LED will blink when Ping command is sent to specific device
[ ] pairing of devices when ID buttons are held down
[ ] unpairing of paired devices when ID buttons are held down
[x ] Toggles LED to identify device
[ x] Device information will be presented on the connected display devices.
[ x] ID LED will blink when Ping command is sent to specific device
[x ] pairing of devices when ID buttons are held down
[ ] unpairing of paired devices when ID buttons are held down
The Bitrate slider is located on the external webpage of which of the following devices?
[ ] encoder
[ ] decoder
[ ] navigator
[ ] network switch
[ x] encoder
[ ] decoder
[ ] navigator
[ ] network switch
Which of the following Network switch setting are required for NAV system deployment?
[ ] 10GPS backplane
[ ] UDP Broadcast configuration
[ ] VLAN enabled
[ ] Energy efficient ethernet disabled
[ ] 10GPS backplane
[ ] UDP Broadcast configuration
[ ] VLAN enabled
[ x] Energy efficient ethernet disabled
True or False: When present on the network, multicast traffic will use a “class D” addressing range to allow devices to send or receive multicast streams.
[ x] true
[ ] false
When configuring a NAVigator, Encoder, or Decoder connected to a managed switch which of the following would be the first item needed for proper setup?
[ ] device name
[ ] location
[ ] ip address
[ ] set proper EDID
[ ] device name
[ ] location
[ x] ip address
[ ] set proper EDID
Which of the following best describes the NAVigator Pro AV over IP system manager?
[ ] user friendly web-based system configuration for up to 500 network end points
[ ] secure encrypted communication between endpoints
[ ] securely manages, configures, and controls NAV pro AV over IP systems
[ ] management bridge for the AV configuration of NAV endpoints
[ ] user friendly web-based system configuration for up to 500 network end points
[ ] secure encrypted communication between endpoints
[ x] securely manages, configures, and controls NAV pro AV over IP systems
[ ] management bridge for the AV configuration of NAV endpoints
True or False: Secure control commands to connected devices, such as a projector, will be sent from the controller directly to the NAVigator prior to passing the command to the end point.
[ ] true
[x ] false
Issues have been occurring on the loop-through monitor. When troubleshooting the problem, which of the following would you look at first?
[ ] decoder
[ ] navigator
[ x] encoder
[ ] network switch
[ ] decoder
[ ] navigator
[ x] encoder
[ ] network switch
which of the following device names would be an appropriate scheme to use in a NAV system?
[ ] source-device (PROJ-E101
[ ] Destination-Device (DISP-SD101
[ ] Device-IP address (E101-192.168.1.1)
[ ] Floor-Room-Device-ID (Floor1-Room1-E101-001)*
[ ] source-device (PROJ-E101_
[ ] Destination-Device (DISP-SD101
[ ] Device-IP address (E101-192.168.1.1)
[ x] Floor-Room-Device-ID (Floor1-Room1-E101-001)
USB in a NAV system supports which of the following?
[ ] host and peripheral devices
[ ] human interface devices - HID
[ ] media transfer
[ ] All of the above
[ ] host and peripheral devices
[ ] human interface devices - HID
[ ] media transfer
[ x] All of the above
Why are the number of source and destination devices in a NAV system regarded as one of the most important considerations in the design process?
[ ] indicates where they will be installed
[ ] indicates the required number of encoder and decoder endpoints
[ ] indicates the signal quality
[ ] indicates the bitrate
[ ] indicates where they will be installed
[ x] indicates the required number of encoder and decoder endpoints
[ ] indicates the signal quality
[ ] indicates the bitrate
NAV encoders and decoders streaming over a 10G NAV network are using which of the following transport methods?
[ ] fiber
[ ] HDMI
[ ] twisted pair
[ ] AES67
[x ] fiber
[ ] HDMI
[ ] twisted pair
[ ] AES67
which of the following is used by the NAVigator pro av over ip system manager and control system for signal routing?
[ ] AES67
[ ] fiber
[ ] usb
[ ] ethernet
[ ] AES67
[ ] fiber
[ ] usb
[ x] ethernet
which of the following audio signal is supported by a NAV system? (select all that apply)
[] embedded HDMI
[] analog
[ ] dvi
[ ] 3G-SDI
[x] embedded HDMI
[x] analog
[ ] dvi
[ ] 3G-SDI
which of the following methods are used for transporting audio in a NAV system? (select all that apply)
[ ] NAV audio
[ ] AES67
[ ] AES70
[ ] Dante
[x] NAV audio
[x] AES67
[ ] AES70
[ ] Dante
which of the following methods allow AES67 to be used for transmitting audio in a NAV system?
[ ] enable NAV audio on a NAV encoder
[ ] enable AES67 on a NAV encoder
[ ] enable NAV audio on a NAV decoder
[ ] enable AES67 on a NAV decoder
[ ] enable NAV audio on a NAV encoder
[ ] enable AES67 on a NAV encoder
[ x] enable NAV audio on a NAV decoder
[ ] enable AES67 on a NAV decoder
which NAV device can be ruled out when troubleshooting a poor signal?
[ ] encoder
[ ] decoder
[ ] NAVigator
[ ] network switch
[ ] encoder
[ ] decoder
[ x] NAVigator
[ ] network switch