N97075 (C172) Memory Items Flashcards
Engine Failure During Takeoff Roll?
- Throttle-Idle
- Brakes-Apply
Engine Failure Immediately after Takeoff?
- Airspeed- 65 KIAS (flaps up) , 60 (flaps down)
Engine Failure During Flight (restart procedures)?
- Airspeed- 75 KIAS
- Carburetor heat- ON
- Fuel Selector Valve- BOTH
Fire During Start on Ground?
- Cranking-Continue
(If engine fails to start) - Throttle-Full Open
- Mixture- Idle, Cut-Off
- Cranking-Continue
Engine fire in flight?
- Mixture- Idle Cut Off
- Fuel Selector- OFF
Electrical fire in flight?
- Master switch- OFF
- Vents/Cabin air/heat- closed
- Fire extinguisher- activate (if available)
Cabin Fire?
- Master Switch- OFF
- Vents/Cabin Air/Heat-Closed
- Fire extinguisher- Activate (if available)
Wing Fire
- Landing light/Taxi light switches- OFF
- Pitot heat switch- OFF
- Navigation light switch- OFF
- Strobe light switch- OFF
Inadvertent Ice Encounter
- Turn pitot heat switch- ON
- Turn back or change altitude
- Pull cabin heat control full out & open defroster outlets.
Static source blockage?
- Static pressure alternate source valve- PULL ON
Power On Stall
1.perform a clearing turn
2. Set the carburetor heat on, and power to 1500 RPM, and hold altitude and heading
3. At 55 KIAS, turn off the carburetor heat, set the power to full, and apply right rudder.
4. Gradually increase pitch, and when you reach the stall buffet, lower the pitch below the horizon.
5. Then smoothly raise the pitch attitude and transition to cruise.
Power-Off Stall with flaps?
At the stall buffet
1. reduce pitch
2. level the wings
3. Add full power
4. Turn off the carburetor heat
5. Apply right rudder pressure
Immediately after applying power,
1. Raise the flaps to 20*
2. Then raise the pitch to climb altitude
As the plane stabilizes, raise the flaps to 10*, and transition to cruise.