MILLWRIGHT INTERPROVINCIAL STUDY GUIDE Flashcards
When combustion occurs in an engine, the force on the piston is transferred to the crankshaft via the:
b) Connecting rod
With a hydrostatic drive system, which valve sets at just above the backpressure in the return line of the main system?
b) Relief
A tongue & groove type of gasket joint and flange face used in industry is classified as:
a) Confined
Which of the following best describes a globe valve?
e) Used for precise fluid flow and have a reduced seat diameter
WHMIS has 3 key elements.
c) Worker education, labeling requirements, MSDS
Which of the following best describes an unloading valve?
a) Used to depressurize part of a system and often used to circulate liquid
Vacuum hoses are designed to conduct gases at pressures ____ atmospheric pressure.
b) Below
At what angle should a ladder be placed?
b) 75°
On a metric micrometre, how many turns on the spindle would one have to make to obtain a measurement of 5 mm?
a) 50
What is the minimum measurement on a metric micrometre?
b) 0.01 mm
When aligning a motor to a pump that was pumping hot liquid, what would you do?
a) Shim the pump higher
Before you start up a new pump, what would you install to protect the pump?
d) Pressure relief valve
The theoretical power of an engine is called the:
b) Indicated horsepower
The type of air filter that throws the dirt particles outward and into a collector is the _____ cleaner.
d) Spiral rotor air
What should be checked if a hydraulic cylinder moves a load slower than it normally would?
c) Supply hose restricted by a kink, or collapsed inner tube
