MH65-D STAN Prep Flashcards

1
Q

Single-engine shaft horsepower (SHP) for the Arriel 2C2-CG engine is?

A

1,005 SHP

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
2
Q

Dual-engine shaft horsepower (SHP) for the Arriel 2C2-CG engine is?

A

712 SHP

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
3
Q

100% MGB torque is?

A

1,294 SHP

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
4
Q

What is module 1 of the Arriel 2C2-CG engine?

A

Accessory Gearbox & Transmission Shaft

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
5
Q

What is module 2 of the Arriel 2C2-CG engine?

A

Axial Compressor

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
6
Q

What is module 3 of the Arriel 2C2-CG engine?

A

Gas Generator

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
7
Q

What is module 4 of the Arriel 2C2-CG engine?

A

Free Power Turbine

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
8
Q

What is module 5 of the Arriel 2C2-CG engine?

A

Reduction Gearbox

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
9
Q

The engine becomes self sustaining at ____% N1.

A

45%

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
10
Q

The reduction gearbox reduces engine speed to ____ RPM.

A

6000

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
11
Q

N1C signal is sent to the ____.

A

EBCAU

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
12
Q

N1A & N1B are sent to the ____.

A

FADEC

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
13
Q

N2A is sent to the ____.

A

Pilot NR Gauge

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
14
Q

N2B & N2C are sent to the ____.

A

VEMD & FADEC

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
15
Q

N2 overspeed protection is provided by the ____.

A

DECU & BIM

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
16
Q

When will the DECU shut down an engine?

A

When the N2 reaches 429 RPM +/- 4

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
17
Q

Where is the stop electro valve located?

A

On top of the gas generator

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
18
Q

Each oil tank holds approximately __ gallons.

A

2 gallons

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
19
Q

MH65-D Oil Type

A

Moil Jet 254

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
20
Q

Max altitude for a free fall deployment of a rescue swimmer is ___ ft.

A

15 ft.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
21
Q

During a lost comms emergency procedure, what step follows checking the HOT MIC switch & helmet connection?

A

Check comms on normal ICS

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
22
Q

What are the approved fuels for the MH-65?

A

JP4, 5, 8, Jet A, A1, A-M & B

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
23
Q

What gas are the floats filled with?

A

Helium

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
24
Q

What is the minimum PSI for the floats?

A

3100 PSI

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
25
What gas is used to fill the blow-down bottles?
Nitrogen or Compressed Air
26
What oil is used in the main gearbox & tail gearbox?
MIL-PRF-6086
27
What oil is used in the hydraulic system?
MIL-H-83282
28
What is the minimum PSI for the blow-down bottle?
1600 PSI
29
Cabin Door Speeds
120 KIAS Removed 100 KIAS Open & Locked 80 KIAS Movement
30
Hoist Hatch Speeds
Open & Locked: 80 KIAS Fwd - 60 KIAS Sideward | Movement: 60 KIAS FWD - 30 KIAS Sideward
31
What is the max airspeed with an external load?
90 KIAS
32
What is the max airspeed with the floats armed/inflated?
90 KIAS
33
Max airspeed with NR HI & angle of bank?
135 KIAS - 40°
34
Max brake speeds with weights?
At or less than 8900lbs - 38 KIAS | Above 8900lbs - 30 KIAS
35
Where are the fire detectors located?
Accessory Section (2 @ 200°C) & Gas Generator (1 @ 400°C) - 3 total.
36
What cells make up the #1 fuel system?
Right FWD, Left FWD, and Left Center
37
What cells make up the #2 fuel system?
Right Center, Right Aft
38
How many pounds of fuel does the feed tank hold?
43 lbs.
39
How many pounds of fuel does the transfer pump move?
600 lbs./hr.
40
What is the max fuel jettison rate?
270lbs./min.
41
What is the PSI of the primary hydraulic system?
870 PSI
42
What is the capacity of the primary hydraulic system?
1 Gallon
43
What components use the primary hydraulic system?
Upper bodies of the MRH servos. Right side of the tail rotor servo.
44
What is the PSI of the secondary hydraulic system?
3000 PSI
45
What is the capacity of the secondary hydraulic system?
2.1 Gallons
46
How much PSI does the recuse hoist use?
3000 PSI
47
How much PSI do the brakes use?
875 PSI
48
How much PSI does the TALON use?
2000 PSI
49
How much PSI do the landing gear use?
2000 PSI
50
What components use the primary hydraulic system?
Lower bodies of the MRH servos. Left side of the tail rotor servo.
51
What is the max load of the rescue hoist?
600 lbs.
52
How much usable cable does the hoist have?
245 ft.
53
What is the speed of the manual override of the hoist?
50 fpm.
54
What are the normal hoist speeds at the FM controls?
200 fpm. First & Last 10 ft. - 50 fpm.
55
What are the normal hoist speeds at the pilot controls?
100 fpm. First & Last 10 ft. - 50 fpm.
56
What is the hoist cable breaking strength?
3200 lbs.
57
What is the overload clutch strength?
1500 lbs. +/- 300 lbs.
58
Hoist rest periods.
No load - No rest 0-300 lbs. - 10 seconds 300-600 lbs. - 30 seconds
59
How long with the aircraft battery power the DC system in an emergency?
30 minutes, or with the CPLT Avionics switch off will extend it 60 minutes.
60
How much power does an external battery supply?
28 VDC
61
How much power does the aircraft battery supply?
24 VDC
62
How much power does the transformer rectifier supply?
28 VDC
63
What does the transformer rectifier do?
Supplies 28 VDC power to both main DC busses, via the No. 2 MGB alternator with 115 VAC - three phase.
64
The engine driven alternators supply ____ at or above ___ % N1.
28 VDC - 60%
65
The top screen of the VEMD displays the ___ page.
FLI
66
The bottom screen of the VEMD is scrollable between the ____ pages.
Vehicle, Fuel, EPC and System Status.
67
If one of the VEMD screens fail the ____ pages are only available.
FLI, Vehicle, Fuel
68
What does the FLI monitor?
N1, Torque (TRQ) and Turbine Outlet Temp. (TOT)
69
What is max continuous power during AEO?
8.8 FLI
70
What is the max takeoff power during AEO?
10.0 FLI
71
What is the max transient power during AEO?
10.7 FLI
72
When does OEI mode happen?
When either engine is lower than 40% N1 or either engine is in IDLE.
73
What is max continuous power during OEI?
Dashed yellow line - 12.4 FLI
74
What is 2 minute OEI?
Dashed red line - 13.2 FLI
75
What is 30 second OEI?
Solid red bar - 13.8 FLI