Liners and Bases

Question 1

why do we use liners and bases?

Answer 1

because a lot of restorative materials don’t adequately protect the pulp against thermal or chemical insult

Question 2

what kind of protection do liners and bases provide?

Answer 2

chemcial, electicla, thermal, mechanical proteciton and pulpal medication

Question 3

conern for pulpal health increaes as______

Answer 3

tooth prep extends closer to the pulp. usually the dentin is a pretty good insulator, but not if it is really thin

Question 4

so what is a liner or base?

Answer 4

material placed between dentin (and sometimes the pulp_ and the restoration to provide pulpal protection.

Question 5

what is a liner?

Answer 5

a relatively thin later f material used primarly to provide a barrer to the dentin from resudual reactants diffusion out of the restoation or oral fluids that can penetrate leaky tooth restorations. contribute to initial ELECTRICAL and THERMAL insulation. provide some pulpal treatment.

Question 6

For what materials are liners usually needed?

Answer 6

They are needed most with deep metallic restoraitons that do not bond to tooth structure such as amalgm and cast gold.

They are not usually used for compoite and ceramic restorations because they are bonded to tooth structure.

Question 7

what are two types of liners?

Answer 7

thin film liners (1-50 um) (examples of these are solution liners and suspension liners)

and cement liners (200-1000um), used for pulpal medication and permal protection)

Question 8

what are cement bases

Answer 8

provide thermal protection for pulp and mechanical support for the restoration.

Also protects the pulp during the condensation of the amg

Question 9

what is a solution liner? What is a suspension liner?

Answer 9

solution liner - any liner based on nonaqueaous solvents that rely on ecaporaiton for hardening

suspension liner - liners based on water that have many consitutions susoended rather than dissolved in them

Question 10

most varnish caotins are produced by ____

Answer 10

dryuing solutions of copal or other resin dissolved in a volatile solvent

Question 11

tooth preps cut with rotary instruments produce debris, some of which is compacted into a layer called the ______. When is this debris left in place? Why is it left in place?

Answer 11

smear layer

left in place for unbonded amalgm restrations. If you are doing something with bodning then you remove the smear layer

If left in place it provides some sealing of teh dental tubules. thuogh it is still about 25% porous.

Question 12

how is flow thorugh tubules related to diameter?

Answer 12

flow is proportional to the dourth power of diameter of the lumen. Therefore, blocking the opening by 50% (x2) decreases flow by a factor of 16.

Question 13

the smear layer is a protective barrier, but is it good for long term protection

Answer 13

heck no.

so for amg restorations that can leak along margins, the smear layer should be sealed to provide chemical protection

Question 14

is a dentin and amg bond a good liner?

Answer 14

yes, it can produce the same or better effect when compared to traditional liners

Question 15

what is the most widely used varnish?

Answer 15

copalite. drying happens in first 8-10 seconds, no need to dry. a thin film is left over the smear layer. moisture is in smear layer and varnish is hydrophobic, so don’t wet it.

see image of coplilite varnish partially occluding the tubules

Question 16

how much does one coat of varnish cover the surface?

How about two coats?

Answer 16

one coat - 55 % of surface

two coats about 80-85% of the surface.

The use of varnishes have decreased a lot since the late 90’s because of the use of bonding

Question 17

is thermal protection better offered by bases or liners?

Answer 17

bases. They are thicker. This is also why they harden by either chemical or light curing.

Question 18

______ can also offer relief of pulpal inflammation and stimulate dentinal bridging

Answer 18

liners

Question 19

what is Eugenol

what is ZOE

Answer 19

in low concentrations, Eugenol eases discomfort from mild to moderate pulpal inflammation.

It can be combined with zinc oxideto form ZOE which is very common in liners, bases, and cements. Zoe liners and bases were used for moderatly-deep preps close to the pulp in the past. Now we use glass ionomers instead.

Question 20

setting of ZOE liners and bases is accelerated by what?

Answer 20

moisture

Question 21

When and why would we use Calcium Hydroxide?

Answer 21

Use when microscopic pulpal exposure is suspected. When ionized in low concentrations, it stimulates fomation of reparative dentin.

CaOH liners are formulated to set quickly, then allow small amounts of CaOH to be released and stimulate reparative dentin. Unfortunately the liners can degrade, at which point they do not provide adequate mechanical support for the restoration.

Question 22

Can you use CaOH and ZOE together?

remember this one peeps, it will be on the exam.

Answer 22

NO!!! Use one or the other. Eugenol chelates the calcium in a strongly exothermic reaction… bad news bears.

Question 23

it appears that ____ is more important than_____ for the purposes of pulpal protection

Answer 23

sealing is more important than medicating for pulpal protection

Question 24

during these time periods, what has been used for pulpal protection?

prior to 1960

1970

1985-1994

1994-present

Answer 24

prior to 1960 - zinc phosphate and resin reinforced ZOE

1970- polucarboxylate cement bases

1985-1994 - glass ionomers

1994-present - highly modified glass ionomer cements provide chemical adhesion, good mechanical strength and potential fluoride release.

see image of glass ionomer cement

Question 25

clinical judgement about when to use liners and bases are linked to?

Answer 25

the remaining dental thickness

Question 26

why do we usually use Ca OH as a liner rather than Eugenol wiht a composite tooth prep?

Answer 26

Because eugenol has the potential to inhibit polymerization of layers of bonding agent or composite that is in contact with it.

Question 27

What is the long term survival of liners and bases like? When should we replace them?

Answer 27

long term survival is not well understood, it is a good idea to replace them when we replace a restoration