Limitations & Emergency Memory Items Flashcards

1
Q

Maximum operating pressure altitude

A

41,000 feet

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
2
Q

Maximum takeoff/landing tailwind component

A

15 knots

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
3
Q

Recommended severe turbulence penetration speed

A

Cruise: TURB N1 setting from cruise page

Climb and descent: 280 knots/.76 Mach

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
4
Q

Takeoff crosswind component (RCC 6/Dry runway)

A

33 knots

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
5
Q

Landing crosswind component (RCC 6/Dry Runway)

A

37 knots

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
6
Q

Landing crosswind component (RCC 5/BRAG/Wet runway/ 1/8” or less)

A

37 knots

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
7
Q

Takeoff crosswind component (RCC 5/BRAG/Wet runway/ 1/8” or less)

A

25 knots

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
8
Q

Icing conditions exist on ground and for takeoff when

A

OAT 10C and below and

Visible moisture (including vis <= 1 Mile)

Standing water, snow, slush may be ingested

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
9
Q

Icing conditions exist in flight when

A

Total air temperature 10C or below and

Visible moisture in any form is present

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
10
Q

On takeoff or missed approach, do not engage autopilot below

A

400 feet AGL

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
11
Q

Min Altitude for use of autopilot on approach (ILS/GLS coupled approaches, no auto land)

A

50 feet AGL

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
12
Q

Min Altitude for use of autopilot on approach (non-precision approaches)

A

50 feet below MDA/DA

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
13
Q

Do not use LVL CHG on final approach

A

Below 1000 feet AFE

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
14
Q

Runaway stabilizer

A
  1. Control column: Hold firmly
  2. Autopilot (if engaged): Disengage
  3. Autothrottle (if engaged): Disengage
  4. Control column & thrust levers: Control airplane pitch attitude & airspeed
  5. Main electric stabilizer trim: Reduce control column forces
  6. Choose one:
    > The runaway stops after the autopilot is disengaged:
    • Do not re-engage the autopilot or autothrottle
      > The runaway continues after the autopilot is disengaged:
    • STAB TRIM CUTOUT switches (both): CUTOUT
    • If the runaway continues:
      • Stabilizer trim wheel: Grasp and hold
How well did you know this?
1
Not at all
2
3
4
5
Perfectly
15
Q

Flight deck door emer entry active light / Automatic unlock

A

JAMCO Flight Deck Door:
1. Flight deck door HARD LOCK switch: Push

Boeing flight deck door:
1. FLT DK DOOR lock selector: Rotate to DENY and hold for 1 second

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
16
Q

Cabin altitude warning or Rapid depressurization/Emergency descent

A
  1. Oxygen masks & regulators: On, 100%
  2. Crew communications: Establish
  3. Seatbelt sign: On
17
Q

Smoke, fire, or fumes

A
  1. Oxygen masks & regulators (as needed): On, 100%

2. Crew communications (as needed): Establish

18
Q

Airspeed unreliable

A
  1. Autopilot (if engaged): Disengage
  2. Autothrottle (if engaged): Disengage
  3. Flight director switches (both): OFF
  4. Set the following GEAR UP pitch attitude & thrust:
    • Flaps extended: 10 degrees & 80% N1
    • Flaps up: 4 degrees & 75% N1
19
Q

Engine start - Aborted start

A
  1. Engine start lever (affected engine): CUTOFF
20
Q

Engine limit / Surge / Stall

A
  1. Autothrottle (if engaged): Disengage
  2. Thrust lever (affected engine): Confirm….Retard until engine indications stay within limits or the thrust lever is closed
21
Q

Engine Fire / Engine Severe Damage / Separation

A
  1. Autothrottle (if engaged): Disengage

2. Thrust lever (affected engine): Confirm….Close

22
Q

Loss of thrust in both engines

A
  1. ENGINE START switches (both): FLT
  2. Engine start levers (both): CUTOFF
  3. When EGT decreases:
    • Engine start levers (both): IDLE detent
23
Q

APU Fire

A
  1. APU fire switch: Confirm….Pull, rotate, and hold
    • Rotate to the stop & hold for 1 second
  2. APU switch: OFF