Lesson 3

Question 1

This will insert a point marker in your drawing at a position
which you pick or at any coordinate location which you enter in the Command
window

Answer 1

Point command

Question 2

Creates a straight line segment. It is used to draw lines continuously. Each
segment is a line object that can be edited separately.

Answer 2

Line

Question 3

Continues a line from the endpoint of the most recently drawn line

Answer 3

Continue

Question 4

End the line segment at the beginning of the first line segment, which forms a
closed loop of line segment.

Answer 4

Close

Question 5

Erases the most recent segment of a line sequence

Answer 5

Undo

Question 6

A command creates a line of infinite length which passes
through two picked points.

Answer 6

Construction line (XLINE)

Question 7

Construction line options

Answer 7

Hor
Ver
Ang
Bisect
Offset

Question 8

A command differs from the LINE command in that the segments of the this
are connected

Answer 8

Polyline (PLINE)

Question 9

sides ranging from 3 to any number can be drawn using _________
command. It creates an equilateral closed polyline

Answer 9

Polygon

Question 10

Specifies the radius of a circle on which all vertices of the polygon
line

Answer 10

Inscribed in circle

Question 11

Specifies the distance from the center of the polygon to the
midpoints of the edges of the polygons

Answer 11

Circumscribe about circle

Question 12

Defines a polygon by specifying the endpoints of the first edge.

Answer 12

Edge

Question 13

This command is used to draw an arc accurately. To create an this, a combination of
centre, endpoint, start point, radius, angle, chord length, and direction values can be
specified.

Answer 13

Arc

Question 14

Defines the radius of the circle.

Answer 14

Center point and Radius

Question 15

Defines the diameter of the circle.

Answer 15

Center point and diameter

Question 16

This command gives you a number of different creation options. The default
option is to pick the two end points of an axis and then a third point to define the
eccentricity

Answer 16

Ellipse

Question 17

It is a special type of polyline which is made up of arc segments. This
has two properties: it has width, and it is closed.

Answer 17

Donut

Question 18

This command is used to fill up the area using a suitable pattern

Answer 18

Hatch

Question 19

Words, messages and numbers can be inserted as required on an engineering
drawing.

Answer 19

Text

Question 20

With this command, the parameters (length, width,
rotation) can be specified control the type of corners (fillet, chamfer, square).

Answer 20

Rectangle