Lathe V1

Question 1

The second work holding device was a

Answer 1

Face plate

Question 2

The Face plate is the ______ for the _______

Answer 2

Driver, Shaft

Question 3

The headstock has a ____ center

Answer 3

Dead

Question 4

The Tailstock has a ____ center with a ____ ____

Answer 4

Live, Internal Bearing

Question 5

A ___ ___ provides a driving force for the workpiece that has been faced and center drilled in Dead and Live centers.

Answer 5

Lathe Dog

Question 6

Using a dial indicator you measure the ____ or ____

Answer 6

Runout or movement

Question 7

Jim used a 4jaw independent to make a ____ that is on his keychain

Answer 7

Crankshaft

Question 8

The 2 types of tool posts in the video

Answer 8

Dovetail, Lantern or Rocker

Question 9

The Lantern tool post has a ____ _____ key in the bottom

Answer 9

Half moon

Question 10

A tool holder holds a ___ ____ and is held with a bigger ___ ____

Answer 10

(smaller)Tool Bits, Bigger tool holder

Question 11

The Bottom of the tool holder is

Answer 11

Thicker

Question 12

Tailstock has a _____ taper

Answer 12

Morse

Question 13

Backing the quill in the tailstock does what

Answer 13

Releases the morse taper

Question 14

Using a ____ ____ you can use smaller morse tapers in a larger morse taper holes

Answer 14

Taper sleeve

Question 15

to remove a tool bit from a taper sleeve you use a

Answer 15

Drift pin