Jeppesen Airframe Ch. 6 Sec. A Flashcards
1
Q
- ______ are used in aircraft dope to make its film flexible.
A
Plasticizers
2
Q
- A dope film should be scrubbed with _____ and water, and any wax removed with an appropriate solvent before the rejuvenator is sprayed on.
A
Scotch-Brite
3
Q
- Rejuvenator is a mixture of potent ____ and ___
A
Solvents, Plasticizers
4
Q
- Rejuvenators restore the ___ to a dried-out dope film.
A
Plasticizers
5
Q
- Finish coats of dope should be sprayed on with a ____ coat.
A
Heavy
6
Q
- Colored dope may be given a glossier finish by mixing it with up to ____ % clear dope.
A
20
7
Q
- The topcoats of a doped finish may peel off if there is a ____ aluminum powder in the aluminum dope coats.
A
Too much
8
Q
- A dope film blushes when ____ condenses out of the air into the freshly applied dope film.
A
Moisture
9
Q
- Mixing ____ with the dope will prevent blushing if the conditions are not too severe.
A
Retarded
10
Q
- The relative humidity of the air may be lowered to prevent blushing by ____ the air.
A
Warming
11
Q
- Two causes for pinholes in a dope film are:
A
Excessive heat or wind
Excessively atomized spray gun air
12
Q
- Three causes for runs and sags in a dope surface are:
A
Moving the gun too slowly.
Holding the work too close.
Not thinning the dope properly.
13
Q
- Orange peel in a dope surface may be caused by:
A
Improper Spraying Techniques.
Thinners Evaporating too quickly.
Air Drafts over the surface.
14
Q
- Localized spots within the dope film that do not dry are called _____.
A
Fisheyes
15
Q
- Dope that is brushed on too heavy or brushed when it is too cold will cause dope ____.
A
Roping
