Jeopardy Flashcards
When does the Master Caution light illuminate for a single/simple fault?
Master Caution Recall
The PSU supplies oxygen, per seat row, for how many minutes?
12 minutes
When do the overwing emergency exit doors locks engage?
A minimum of three of the four entry/service doors are
closed, and either engine is running, and the aircraft
air/ground logic indicates that the aircraft is in the air or
both thrust levers are advanced.
What is the function of the Electric Air Compressor?
This supplies pressurized air to the Potable Water Tank
when the pneumatic system is insufficient and is
powered by Main Bus number 1.
With both the LED Landing lights ON and Taxi Light ON/AUTO the taxi
light function is ______ by the landing light function.
with both the LED Landing and Taxi Light ON/AUTO the
taxi light function is overridden by the landing light
function
Pressurization Panel: The AUTO FAIL (amber) light illuminates if any of
the following conditions occur: (name one)
Loss of DC power or Controller fault or Outflow Valve
control fault or Excessive differential pressure or Excessive
rate of cabin pressure change or High cabin Altitude.
The Wing Body Overheat (amber) light, when illuminated, indicates
what?
an overheat has been detected
Thrust must be limited to idle with the __________ light illuminated.
Dual Bleed
What does a Bleed Trip Off light indicate?
excessively high bleed air Temperature (254⁰C) OR
excessively high Pressure(220psi) and may be reset
with the trip/reset button if conditions permit.
The MAX pneumatic systems use ______ and _______ stage bleed
air.
4th and 10th
What are your indications when you receive a SELCAL? _______ and
_________ .
SELCAL white light and Two-tone chime
Which radio defaults to DATA on power up and at power down?
VHF 3
The Radio Tuning Panel (RTP) displays __________ when the
selected radio is not available.
FAIL- FAIL
What does an illuminated Offside Tuning (white) Light indicate?
The radio normally associated with this panel is being
tuned by another radio tuning panel, or the radio tuning
panel is being used to tune a radio not normally
associated with this radio tuning panel.
On the MAX, where is the SELCAL light?
Just below the Mic selector, on the ACP.
With the Ignition Select System at IGN R, what is the power source?
AC Standby Bus
What will remove an amber ENG FAIL indication?
The engine recovers, the start lever is moved to
CUTOFF, or the fire switch is pulled.
What does the THRUST crew alert on the Engine Display indicate?
The associated engine thrust is more or less than the
commanded thrust. THRUST is displayed in conjunction
with the N1 command sector illuminating amber.
The Thrust Mode Display (green) indicates R-TO. What mode is
active? _____________________.
reduced takeoff
In the MAX, how long should you wait after the APU GEN OFF BUS
(blue) light extinguishes before the positioning the Battery Switch to
OFF? (CW)
3 minutes
During a FAULT/INOP test, the failure of the FAULT light to illuminate
indicates _________.
the Fault Monitoring System is inoperative
If the OVHT DET switch is positioned to A or B, the system operates as……….
a single loop system
Rotating an Engine Fire Switch in one direction
____________________.
electrically fires a squib, discharging the extinguisher
into the related engine
How long do we have fire suppression after the Cargo DISCH switch is
pushed?
195 minutes
The MAX has how many wheel well fire detector loops?
Two
The Fuel LOW (amber) Alert is displayed when the respective Main
Tank fuel quantity is less than _________ for greater than _________.
2000 lbs 30 seconds
Aside from a leak, what could cause a progressive fuel imbalance?
the Crossfeed Valve open, no Center Tank fuel feed,
Main Tank Fuel Pumps operating within the normal
pump output pressure tolerances
Opening the Crossfeed valve inflight, ______________.
allows fuel from a main tank, with operating fuel pumps,
to provide fuel to both engines
