JC NET+CH10 ROUTING PROTOCOLS Flashcards
WHAT IS FIRST HOPE REDUNDNACY PROTOCOL (FHRP)
WORK BY GIING YOU A WAY TO CONFIGURE MORE THAN ONE PHYSICAL ROUTER TO APPREAR AS IF THEY WERE ONLY A SINGLE LOGICAL ONE
WHO IS RESPONSIBEL FOR DECIDING WHICH PHYSICAL ROUTER WILL ACTIVELY FORWARD TRAFFIC AND WHICH ONE WILL BE IN STADBY IN CASE THE ACTIVE ROUTER FAILS
REDUDANCY PROTOCOL PAGE 318
FALT TOLERANTS SOLUTION DOES WHAT
PROVIDES CONTINUED OPERATION IN THE EVENT OF A DEVICE FAILURE, AND LOAD BALANING SOLUTION DISTRIBUTION THE WORKLOAD OVER MULTIPLE IP PAGE 318
WHAT IS HOT STANDBY ROUTER PROTOCOL (HSRP)
ALLOWS YOU TO CONFIGURE TOW OR MORE TROUTERS INTO A STANDBY GATEWAY PAGE 319
HOW DO YOU ACHIEVE OAD BALANCING WITH HSRP
BY USING MULTIPLE VLAND AND DESIGNATE A SPECIFIC ROUTER FOR ONE VLAN, THAN AN ALTERNTE ROUTER AS ACTIVE FOR VLAND VIA TRUCKING PAGE 319
WHAT IS CONSIDER CISCO PROPRIETARY PROTOCOL
HSRP PAGE 319
WHAT ARE SOME OF THE PROBLEMS WITH HSRP
- ONLY ONE ROUTER CAN BE ACTIVE AND THE OTHER 2 OR 3 JUST SIT THERE IN STANDBY MODE AND WONT BE USE UNLESS A FAIL OCCUR
- NOT VERY COST EFFECTIVE OR EFFEICENT PAGE 319
WHAT IS A HELLO MESSAGE
CONTAIN THE INFORMATION REQUIRED TO ACCOMPLISH THE ELECTION THAT DETERMINES THE ACTIVE AND STANDBY ROUTER POSITION PAGE 320
WHAT ARE THE FUNCTION OF HSRP TIMER
TO ENSURE COMMUNICATION BETWEEK THE ROUTER, AND IF SOMETHING GOES WRONG, THEY LLOW THE STANDBY ROUTER TO TAKE OVER PAGE 322
WHAT IS THE DEFUALT INTERVAL OF THE HELLO TIMER
3 SECONDS PAGE 322
ALSO ALL THE TIMER IDENTIFY THE STATE OF RSVH ROUTER PAGE
WHAT IS THE HOLD TIMER
10 SECOND PAGE 323
WHAT IS THE PURPOSE OF THE ACTIVE TIMER
MONITORS THE STATE OF THE ACTIVE ROUTER PAGE 323
WHAT PROTOCOL ALLOW A GROUP OF ROUTER TO FORM A SINGLE VIRTURAL ROUTER
VIRTUAL ROUTER REDUNDANCY PROTOCL (VRRP) PAGE 324
WHAT IS THE MAX HOP COUNT FOR RIPNG
15 PAGE 325
WHAT PORT DOES RIPDG USES
UDP PORT 512 PAGE 325
