inspect Flashcards
SOAP results are reported in parts per…
million.
For a compression check, what is regarded as excessive compression loss?
25%.
Where can you find items that must be inspected during an Annual/100 Hr. inspection?
FAR Part 43 Appendix D.
What does the FAA require you to use if conducting a 100 Hr/Annual inspection?
Inspection Check List.
Does an inspection record require a statement of airworthiness?
Yes.
During a failed compression check air is heard hissing from the breather tube. What is the source of the leak?
Piston rings.
Conducting a compression check you pressurize the cylinder with 80 psi of nitrogen. The differential pressure is 71 psi. How do you record the result?
71/80
In performing a 100 Hr. Inspection you find seven faults making the aircraft unairworthy. The owner agrees to correct only three of them. Can you make a log entry stating the 100 Hr inspection has completed?
Yes.
Requirements for recording Major Repairs or Alterations are found in:
FAR Part 43 Appendix B.
For airline and corporate operators, Annual/100 Hr inspections have been replaced with:
Progressive Inspection Programs.
Advisory Circulars are:
suggestions endorsed by the FAA.
Which FAR Part states an aircraft’s registration must be displayed in the aircraft?
Part 91.
The inspection of engine parts during overhaul is divided into which three categories?
Visual, Structural NDT, Dimensional.
A visual inspection immediately follows disassembly, all individual parts should be laid out how?
In an orderly manner as they are removed.
QECA stands for…
Quick Engine Change Assembly.
The nuts on the engine mount must be tightened to the torque recommended by..
The engine manufacturer.
A likely cause of a reciprocating engine to have a cold (dead) cylinder would be:
Defective sparks plugs.
For inspection purposes, the turbine engine is divided into two main sections:
Cold and Hot.
Minor damage to axial-flow engine compressor blades may be repaired if…
the damage can be removed without exceeding allowable limits.
The inspection of engine parts during overhaul is divided into these three categories:
Visual, Structural NDT, Dimensional.
Which are the two types of inspection used in the Progressive Inspection Program?
Routine and Detailed.
During a 100 hour engine inspection, before approval for return to service, the following must be checked for:
Alternator and starter operation.
Items performed in engine 100 hour inspections must include…
the scope and detail of items contained in CFR Part 43 Appendix D.
Which of the following can inspect and approve an engine major repair for return to service?
Certificated mechanic with inspection authorization.
