Induction Systems

Question 1

Name the three components on the induction system of a reciprocating engine.

Answer 1

The air scoop, carburetor, or fuel control, and the intake manifold.

Question 2

What could happen if the induction system becomes obstructed?

Answer 2

The engine may not be able to produce its rated power or it may not run at all. This may also be an indication of a dirty air inlet filter.

Question 3

How does induction icing affect engine performance?

Answer 3

It causes a reduction in power and possible erratic operation.

Question 4

How is induction icing categorized?

Answer 4

As impact ice, fuel evaporation ice, and throttle ice.

Question 5

What is the common method used to prevent induction system ice in a reciprocating engine?

Answer 5

Raise the temperature of induction air with a preheater.

Question 6

What causes fuel evaporation ice?

Answer 6

Fuel evaporation ice is formed because of the decrease in air temperature resulting from evaporation of the fuel after it is introduced into the air stream.

Question 7

Is carburetor throttle ice more likely to occur at a higher or lower power setting? Why?

Answer 7

At a lower power setting because the throttle is partly closed, offering a larger surface area for ice accumulation.

Question 8

What may be the indication of leaking intake pipes?

Answer 8

The engine runs rough at low rpm.

Question 9

What happens to engine power when the carburetor heat is applied?

Answer 9

There is a noticeable drop in power.

Question 10

What could happen if carburetor heat is applied at high engine power settings?

Answer 10

Detonation.

Question 11

What are the two types of supercharged induction systems?

Answer 11

Internally driven and externally driven.

Question 12

How and at what point does an internally driven supercharger boost air pressure?

Answer 12

An (engine-driven) impeller compresses the fuel/air mixture after it leaves the carburetor.

Question 13

What is used to power a turbocharger?

Answer 13

Engine exhaust gas directed onto the turbocharger turbine.

Question 14

What could result if the waste gate on a turbocharger system does not close fully?

Answer 14

The engine may not be able to produce its rated power at certain altitudes, and the aircraft may not be capable of reaching critical altitude.

Question 15

What function does a turbocharger waste gate perform?

Answer 15

It controls the amount of exhaust gas either into or around the turbocharger, thus controlling the boot pressure of the turbocharger.

Question 16

What could cause a turbocharged engine to surge?

Answer 16

There could be a waste gate or controller malfunction.

Question 17

What are the most common ways to control a waste gate?

Answer 17

Either mechanically with linkages to the throttle or a separate control, or by an actuator that is driven by oil pressure.

Question 18

In a pressurized reciprocating aircraft, what component I the turbocharger system is used to limit the amount of turbocharger airflow used for cabin pressurization?

Answer 18

The sonic venturi.

Question 19

What is the function of a divergent-shaped jet engine inlet during subsonic flight?

Answer 19

It causes the air velocity to decrease with a subsequent increase in air pressure.

Question 20

Where are bellmouth inlet ducts typically found?

Answer 20

On helicopter engines.

Question 21

How do Venturi-type particle separators, found on many turbine powered helicopters, function?

Answer 21

A venturi is used to accelerate the flow of incoming air and debris through a curved intake. The debris gains too much inertia to allow it to follow the curved intake towards the engine, and is channeled away from the compressor.

Question 22

What are the most common methods used for anti-icing of turbine engine inlet ducts?

Answer 22

Engine bleed air and electric heating elements.