HVAC 6024 - Warm Air Heating System Equipment (Chp 6) Flashcards
Heat may be added to a building's forced air system by means of: A) Duct silencers B) Fans C) Fin-coil heat exchangers D) Dampers E) Electronic control
C) Fin-coil heat exchangers
In high efficiency furnaces, if the temperature of the flue gas drops below 65°C, the: A) Water vapor will condense B) Furnace vent will close C) Furnace burner will start up D) Furnace burner will shut down E) Flue gas will condense
A) Water vapor will condense
One of the advantages forced warm air heating systems has over steam or hot water heating systems is the:
A) Ease of installation of the air duct B) Systems are virtually noise free C) Systems are maintenance free D) Air can be humidified and filtered E) Systems do not require electricity
D) Air can be humidified and filtered
A pulse combination condensing furnace stated efficiency is:
A) 80 - 95% B) 94 - 98% C) 70 - 75% D) 60 - 70% E) 50 - 60%
B) 94 - 98%
gVarious types of heat sources are used in warm air heating systems. They can be divided into the following classes:
- Indirectly-fired
- Directly fired
- Electric resistance coil
- High voltage coil
- Fin-coil heat exchanger
A) 1, 2, 3 B) 3, 4, 5 C) 2, 3, 5 D) 1, 3, 4 E) 2, 3, 4
C) 2, 3, 5
Three types of direct fired forced warm air furnaces are:
A) Zone, direct volume and variable volume
B) Steam unit ventilators, hot water unit ventilators, and finned hot water convection
C) Horizontal, upflow and downflow
D) Dual duct, terminal reheat, and constant volume
E) Hydronic, steam, and finned electric
C) Horizontal, upflow and downflow
High efficiency warm air furnaces require: A) Increased gas pressure B) Large vent stacks C) Larger fans D) Condensate drains to waste E) More air
D) Condensate drains to waste
In a warm air heating system, the cold air return registers are located: A) In floors B) In ceilings C) Under windows D) In interior locations E) In exterior walls
D) In interior locations
An advantage of an electric resistance warm air furnace is: A) Lower installation cost B) More efficient C) Elimination of burners and fuel D) All of these are correct E) More compact
D) All of these are correct