General Flashcards
What are the maximum and minimum supply voltages
DC- 14-32V
AC- 98-132V
What MGB temps bring on the red and yellow warning lights
Yellow= 128º Red= 210º
What OEI mode does the blue line indicate
> 60 kts= LO
<60 kts= HI
What condition brings on the emergency cabin lights when armed
No power on the Secondary Bus. Powered by the Ess Bus, if not the Emerg Batt
What is the tail rotor RPM
1293 RPM
What condition caused the AP to engage FLYUP mode
CRHT coupled with a loss height 30’ below bugged or 200’ whichever lower
Till what N1 must a finger be kept on the start switch
65%
With the discrepancy of a gauge parameter between AMC 1 & 2, what will the gauge show on the EID
An empty yellow arc
What condition will bring on the amber TEMP light on the elec panel
A 10% temperature difference between inside and out
Below what height should hand and feet be on the controls
200’
What is the maximum temp of the TGB
94ºC
At what pressure will the MP caption illuminate
3.65 bar
What condition will bring on the red BAT.T caption
Temperature exceeding 70º
Below what N1 will a start sequence initiate
10%
With IAS coupled, what is considered excess deviation
12 kts with a 5 sec delay
At what point does the LH LVL light illuminate
4 litres
What warning would accompany LH LVL warning to verify a loss of fluid
AP.P
What fuel SG is to be used for flow calculations
0.79 at 15ºC
What is the operating range for the heater mats
On at <5ºC, off at 10ºC
With the MGB pump operating normally, at what pressure does the S/B.P caption illuminate
2.6 bar
With V/S coupled, what is considered excess deviation
500’ min with a 5 sec delay
What is the operating pressure of the AP hydraulics
103 bar
At what N1 do the engines idle
68%