functions of drop table

Question 1

how many drop pieces per table

Answer 1

4

Question 2

how many weighting dials

Answer 2

4

Question 3

what are weighting dials used for

Answer 3

setting the correct amount of weight resistance for HVLA adjustment

Question 4

rule of thumb

Answer 4

low force = less resistance
high force = more resistance

Question 5

OMNI = how to set drop piece

Answer 5

1. tighten the tension, being careful to not over tighten (turn clockwise)
   2.use the handle or foot step to cock the piece
2. slowly loosen the tension until drop
3. turn tension knob clockwise about 3-4 half turns
   5 raise piece again and adjust

Question 6

OMNI = when adjusting the lumbar segments where should they be placed

Answer 6

between lumbar and pelvic drops pieces

Question 7

ZENITH 320L- Headpiece flexion and extension is used for…

Answer 7

• used to open up facet spaces

Question 8

ZENITH 320 HYLO extra features

Answer 8

• hand controls, push red button in the centre then the up or down arrows to raise and lower table
• foot plate, gently push in towards the table then push down on either the raise or lower side

Question 9

ZENITH 320 HYLO what is red button on foot control for

Answer 9

used for emergency stop

Question 10

how to set up ZENITH 440 HYDRAULIC pelvic, lumbar, thoracic

Answer 10

select the option you want on dial

Question 11

how to set up ZENITH 440 HYDRAULIC cervical drop

Answer 11

1. select d on drop dial
2. turn cerv. drop dial to engage the piece
3. to cock step on white strip on ground