Foam Pro

Question 1

The minimum Foam Pro operation rate is what PSI

Answer 1

30 PSI

Question 2

The Foam Pro has a ______ digit display

Answer 2

5

Question 3

When changing the Foam Pro percentage setting, hold the button down for how many seconds?

Answer 3

2

Question 4

The Foam Pro CAL/INJECT valve handle shall be _______ for normal operation

Answer 4

In-Line

Question 5

The Foam Pro CAL/INJECT valve handle shall be _______ for calibration operation

Answer 5

90 Degrees

Question 6

The KME uses a foam concentration refill wand that is 1” in diameter and how long?

Answer 6

6’

Question 7

The KME foam tank can be filled through the “power fill” system. The red button places the pump in what mode?

Answer 7

Manual

Question 8

The KME has an automatic refill system. Push the ______ button to start the foam pump motor.

Answer 8

Green

Question 9

The KME has an manual refill system. Do not press the HOLD button for too long or else?

Answer 9

The tank may overflow.

Question 10

The Foam Pro proportions at what percentage ranges?

Answer 10

0.1 to 3 %

Question 11

The Fro Pro is a ___ side, direct injection foam system?

Answer 11

Discharge

Question 12

The Fro Pro system is solely based upon?

Answer 12

Water Flow

Question 13

The “ON” status lamp will ___ when foam is being injected. The system wil monitor

Answer 13

Flash

Question 14

What is the Foam Pro operational PSI

Answer 14

400

Question 15

The foam Button is located in the upper-Left screen corner. The button is?

Answer 15

Red

Question 16

Can different brands of Class “A” foam or different types of foam such as Class “B” be mixed together
in the same tank?

Answer 16

Never

Question 17

Foam Pro motor stall protection is provided in the event the pump motor will not run or stalls for 10

seconds. The display will show __ which indicates the pump is producing no feedback to the control
signal. The system will return off to protect the electric motor.

Answer 17

ERR.EL