Fluid Lines And Fittings Flashcards

1
Q

How tight should an MS flareless fitting be tightened?

A

Tighten the fitting by hand until it is snug, and then turn it with a wrench for ⅙-turn to ⅓-turn. Never turn it more than ⅓-turn with a wrench.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
2
Q

What damage can be caused by over tightening an MS flareless fitting?

A

Over tightening it drives the cutting edge of the sleeve deep into the tube and weakens it.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
3
Q

What kind of rigid tubing can be flared with a double flare?

A

5052-0 and 6061-T aluminum alloy tubing in sizes from ⅛-inch to ⅜-inch OD.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
4
Q

What should be done to the end of a tube that is to be flared?

A

The cut end should be polished to remove any sharp edges that could cause the tubing to crack.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly