Flows Flashcards
0
Q
Safety Equipment (8)
A
- Flashlights (2)
- Crash Axe
- Fire Extinguisher
- Smoke Goggles (2)
- Hydraulic Handpump Handle
- Life Jackets (3)
- Escape Rope
- PBE
1
Q
Flight Compartment Safety Check
A
- Radar
- Emergency Brake/Pressure & Control Lock
- Landing Gear
- Batteries & Main Bus Tie
- GPU/APU
- Position Lights
- Safety Equipment
2
Q
DC External Power Up Procedure
A
- Battery Master/Main, Aux & Stby - On
- Main Bus Tie - Tie
- DC Ext Power - On
- MFD #2 - On
- Bus Voltage - Checked
- Recirc Fan - On
3
Q
APU Power Up Procedure
A
- Battery Master/Main, Aux & Stby - On
- Main Bus Tie - Tie
- MFD #2 - On
- Caution/Advisory Lights - Test
- APU Power - On
- APU Fuel Valve - Open
- APU Fire Detection - Test
- APU Fuel Valve - Open
- APU Start - Press
- APU Run - On
- APU Gen - Press
- APU Gen Volts/Load - Checked
- Battery Temperature - Checked
- Bleed Air 1 and 2 - Off
- APU Bleed Air (20 sec) - As Required
- Temp Control - Set
- Recirc Fan - On
4
Q
Batteries Only Power Up Procedure
A
- DC Gen 1 and 2 - On
- Main Bus Tie - Tie ⬆
- Ice Protection - Off
- Exterior Lighting - Off
- Ignition 1 and 2 - Norm
- Recirc Fan - On
- Bleed Air 1 and 2 - Min/Off
- Emergency Lights - Arm
- Passenger Signs - On
- Power Levers - Disc
- Briefing - Complete
- Start Approved
- Battery Master/Main Aux & Stby - On
- Fire Detection - Test
- Emergency Brake/Pressure - Park/Checked
- Doors/Fueling Lights - Out
- Emergency Lights - Arm ⬇
- Engine - Clear for Start
5
Q
Documents Library (12)
A
- Aircraft Flight/Maintenance Logbook
- Registration and Certificate of Airworthiness
- Aircraft Systems Manual
- Emergency Descent Checklist
- Minimum Equipment List
- Quick Reference Handbook
- TOLD Cards
- ACM Jumpseat Briefing Card
- Normal Checklist
- Republic Airways TDP Checklist
- ACARS-Unavailable Takeoff Performance Worksheet
- Captain’s Deicing and Anti-Icing Worksheet
6
Q
Takeoff Briefing
A
- Identification of PF (CA or FO)
- Runway planned for takeoff
- Planned takeoff weight
- Planned flap setting and V speeds
- Minimum safe altitude
- Initial takeoff clearance/course and altitude
- Lower-than-standard takeoff and takeoff alternate(s) if applicable
- Special takeoff departure procedures
- Emergency procedures below and above V1
- Summarize applicable special considerations peviously briefed and any new considerations
- Weather conditions and any adverse conditions
7
Q
Engine Start
A
- Flight Deck Door - Locked
- Verify V Speeds
- Verify Voltage above 22 volts
8
Q
After Start
A
-Ext Power/APU Power - Off
-Main Bus Tie - Off
-Pitot Static Switches - On
-Windshield Heat - As Required
-Spoilers - Taxi
-DC Loads/Battery Temps - Checked
-Radar - Standby
===(After pushback)===
-Condition Levers - Max
-Flaps - Set for Takeoff
-Rudder Travel - Checked
-Nose Steering - On
9
Q
Taxi
A
- Taxi the airplane
- Takeoff Warning Check - Complete
10
Q
Before Takeoff
A
- Visually check the flight guidance and ED
- Spoilers - Flight
- Exterior Lights - All On
- Confirm heading bug with assigned runway
11
Q
After Takeoff Check
A
PM: -Flaps - Zero -Climb Power - Set -Autofeather - Off -Tank AUX Pumps (1 and 2) - Off -STBY HYD Pressure and PTU Control - Off (dark) -Engine Temps and Pressure - Checked -Ice Protection - As Required "After Takeoff Check Complete"
12
Q
Approach Briefing
A
PF transfer controls to PM
- Approach Name and Runway
- Approach chart date
- Primary nav-aid frequency
- Final approach course
- Final approach fix
- DA or MDA/MAP
- TDZE
- Highest MSA
- Approach lighting system
- Missed approach procedure
- Required visibility
- Any special considerations
- Weight, Flap and V Speeds for landing set per the TLR or TOLD cards
13
Q
In Range
A
PM: V Speeds - Set Cabin PA Announcement - Complete Altimeters - Set Cabin Altitude Controls - Set Ice Protection - As Required Fasten Belts - On GPWS Flap Setting - Set Fuel Transfer - Off Tank Aux Pumps (1 and 2) - On Read Checklist - "In Range Checklist Complete"
14
Q
After Landing
A
Land/Approach Lights - Off
Anti-collision Lights - Red
Spoilers - Taxi
