Finals Flashcards
Finals study guide
In a dado joint, a(n) ___ across one board receives the end of another board.
Dado
To lay out a dado, superimpose the end of the second board across the ___ of the first
face
The correct depth for a dado is usually ___ the thickness of the stock
one half
After cutting the dado, use ___ to check the depth throughout
a combination square
In a(n) _____ joint, the dado is cut only part way across the board and the piece that fits into the dado is notched so the joint does not show from the front
blind dado
An attachment called a(n) ___ can be mounted on a table saw and used to make dadoes.
dado
A rabbet-and-dado joint consists of a rabbet with a(n) ___ that fits into the first dado
tongue
To make a rabbet-and-dado joint, first lay out and cut the ___
rabbet
Technically a dado is cut across the grain, a groove is cut with the grain True or False?
True
To make dado joints more attractive on a bookcase decorative cuts can be made on the front ends of the shelves True or False?
True
Wooden drawer bottoms should be glued and then nailed to the drawer frames to prevent changes caused by humidity True or False?
False
A rabbet and dado joint is used when increased strength and stiffness are required True or False?
True
The strength of a dado joint is largely determined by how much of the surface area of one piece is in contact with the adjoining piece True or False?
True
Make sure that the saw kerfs for the dado are made outside the layout lines True or False?
False
If the second piece of the joint fits a but snugly into the first piece, use sandpaper to smooth out the channel True or False?
True
