final Flashcards
Which of the following are required when adding a network to the OSPF routing process configuration?
network address?
network address
wildcard mask
area id
Which of the following are primary functions of a router? (Choose two.)
packet switching
path slection
Refer to the exhibit. When troubleshooting a network, it is important to interpret the output of various router commands. On the basis of the exhibit, which three statements are true? (Choose three.)
The missing information for Blank 1 is the command show ip route.
The missing information for Blank 2 is the number 120
The missing information for Blank 3 is the letter C.
Refer to the exhibit. Packets destined to which two networks will require the router to perform a recursive lookup? (Choose two.)
When would the network administrator use the ip bandwidth-percent eigrp as-number percent command?
when there is a low bandwidth connection
Refer to the exhibit. Cost for each path are shown. If all routers are configured to use OSPF, what would be the path of a packet sent from Router C to Router D if Router A was down
C-F-E-D
What OSPF packet type is used to elect the designated router (DR) and backup designated router (BDR) on multiaccess networks?
hello
Refer to the exhibit. The hosts on the R1 LAN are unable to access the Internet. What is incorrectly configured
the IP address of the S0/0/0 interface at R1
Refer to the exhibit. Which summarization should R1 use to advertise its networks to R2
192.168.0.0/22
Refer to the exhibit. What are two of the routes added to the routing table of R1? (Choose two.)
R 192.168.1.0/24 [120/1] via 172.16.2.1, 00:00:24, Serial0/0/1
R 192.168.100.0/24 [120/1] via 172.16.1.1, 00:00:24, Serial0/0/0
A router boots and enters setup mode. What is the reason for this?
The configuration file is missing from NVRAM.
Refer to the exhibit. A router learns a route to the 192.168.6.0 network, as shown in the output of the show ip rip database command. However, upon running the show ip route command, the network administrator sees that the router has installed a different route to the 192.168.6.0 network learned via EIGRP. What could be the reason for the missing RIP route?
Compared to RIP, EIGRP has a lower administrative distance.
ll routers in a network are configured in a single OSPF area with the same priority value. No loopback interface has been set on any of the routers. Which secondary value will the routers use to determine the router ID?
The highest IP address among the active interfaces will be used.
Refer to the exhibit. Routers R1 and R2 are directly connected via their serial interfaces and are both running the EIGRP routing protocol. R1 and R2 can ping the directly connected serial interface of their neighbor, but they cannot form an EIGRP neighbor adjacency.
What action should be taken to solve this problem?
Configure both routers with the same EIGRP process ID
