EMER ELEC PWR Panel (Odd)

Question 1

What is the significance of the red FAULT illuminating on the RAT & EMER GEN light?

Answer 1

AC BUS 1 and AC BUS 2 are lost, and the emergency generator is not supplying electrical power

Question 2

When would the red FAULT light on the RAT & EMER GEN light normally
illuminate?

Answer 2

The fault light will illuminate once the RAT is deployed and electrical power is not being supplied (approximately eight seconds)

Question 3

How can the RAT be deployed?

Answer 3

• Manually by pushing MAN ON (EMER ELEC PWR Panel) or RAT MAN ON
  (HYDRAULIC Panel).
• Automatically by the loss of both AC BUS 1 and AC BUS 2

Question 4

What is the difference between the automatic RAT deployment and manual RAT deployment by pressing the RAT MAN ON on the HYD panel?

Answer 4

RAT MAN ON supplies Blue Hydraulic pressure only, no electrical generation

Question 5

After deploying the RAT by pressing the RAT MAN ON pushbutton on the
HYD panel it becomes necessary to also extract electrical power. How can
this be accomplished?

Answer 5

By pressing the MAN ON pushbutton on the EMER ELEC PWR

Question 6

What does the RAT supply?

Answer 6

Blue Hydraulic System pressure and the emergency electrical generator

Question 7

What would cause the GEN 1 LINE SMOKE light to illuminate?

Answer 7

Smoke detectors (particle detectors) in the avionics ventilation ducting

Question 8

Aside from the GEN 1 LINE SMOKE light, what would be other indications of avionics smoke?

Answer 8

• ECAM warning
• Amber FAULT lights in the EXTRACT and BLOWER pushbuttons on the
  VENTILATION panel.

Question 9

If the ECAM directs a pilot to select GEN 1 LINE pb sw to OFF, what will be
accomplished?

Answer 9

• Gen 1 line contactor opens (white OFF light illuminates)
• AC BUS 1 powered by GEN 2 through the Bus Tie Contactors
• Gen 1 powers one fuel pump directly in each wing tank