ELECTRONIC HAND TOOLS AND EQUIPMENT

Question 1

These are hand tools specifically designed to insert and tighten or to loosen and remove screws.

Answer 1

SCREWDRIVERS

Question 2

is used to drive or fasten negative slotted screws.

Answer 2

a. Slotted / Flat Screwdriver

Question 3

used to drive or fasten positive slotted screws.

Answer 3

b. Phillips Screwdriver

Question 4

Precision Screwdriver Set

Answer 4

Precision Screwdriver Set

Question 5

It is a device for applying heat to melt solder in attaching two metal parts.

Answer 5

Soldering Iron

Question 6

is a place where the soldering iron is placed during usage.

Answer 6

Soldering Tool Stand

Question 7

is used in removing soldered wires and components on printed circuit boards for troubleshooting and repair purposes.

Answer 7

Desoldering tool

Question 8

is used for holding, bending, and stretching the lead of electronic component or connecting wires.

Answer 8

Long Nose Pliers

Question 9

is a wire-cutting pliers, though they are not used to grab or turn anything, but are used to cut wires.

Answer 9

Side Cutter

Question 10

is a pair of opposing blades much like scissors or wire cutters

Answer 10

Wire Stripper

Question 11

is used to bore or drill holes in the printed circuit board (PCB) with sizes from 1/32” – 1/16”

Answer 11

12V Mini-Drill

Question 12

is used for boring hole(s) in plastic or metal chassis with the used of drill bits having sizes from 1/6” to approximately 1/4”.

Answer 12

Portable Electric Drill

Question 13

These are hand tools having a series of sharp, parallel ridges or teeth. Most files have a narrow, pointed tang at one end to which a handle can be fitted.

Answer 13

Metal Files

Question 14

parallel in width and tapered in thickness; they are used for flat surfaces and edges

Answer 14

Flat file

Question 15

tapered in width and thickness, coming to a point, and is a narrow than a standard half round and use for filling inside of rings

Answer 15

Half round file

Question 16

it is also called rat-tail which is gradually tapered and used for many tasks that require a round tool, such as enlarging round holes or cutting a scalloped edge

Answer 16

Round file

Question 17

is a common tool used in cutting various trades and crafts for a variety of purposes

Answer 17

Utility Knife

Question 18

is used for cutting metals. Some have pistol grips which keep the hacksaw firm and easy to grip.

Answer 18

Hacksaw

Question 19

is a convex lens which is used to produce a magnified image of an object.

Answer 19

Magnifying Glass

Question 20

made of bristles set in handle, use for cleaning dirty parts of a circuit or an object.

Answer 20

Paint Brush

Question 21

It is an equipment that combines three functions: as a voltmeter that measures both ac and dc voltages; an ohmmeter that measures resistance; and milliammeter that measures small amount of dc current. As safety precautions in the maintenance of this instrument, the following should be observe

Answer 21

Volt-Ohm-Milliammeter

Question 22

commonly abbreviated CRO, for cathode-ray oscilloscope, or scope is a piece of electronic test equipment that allows signal voltages to be viewed, usually as a two-dimensional graph of one or more electrical potential differences (vertical axis) plotted as a function of time or of some other voltage (horizontal axis)

Answer 22

Oscilloscope

Question 23

A signal generator is a device which produces simple wave forms.

Answer 23

Signal generator