Electrical Intro. 10/23 Flashcards
How many overloads for a 3 phase motor
3
Start stop is what type of switch?
Momentary
What are used to tell you if a motor is running?
Indicating lights
NEMA stands for?
National Electrical manufacturers association
What 4 different components up an electrical circuit?
Wiring
source voltage
switches
loads
A float switch is installed in what position?
Normally open
What part of a DC motor is meant to wear out?
Brushes
High voltage side of a transformer is known as?
Primary
What holds the starter circuit closed when the momentary start button is released?
Seal in tips
What voltage is supplied to a control transformer?
480VAC
What can be used as a temporary solution to fix a wiring issue?
Jumper wire.
Size of a starter is based on what?
Motor HP
4 types of motors
Single phase
single phase capacitor start
3 phase
DC
Symbol for fuse
To change the rotation of a DC motor you swap the?
Polarity (A-1,A-2)
What needs to be installed in the motor circuit to enable auto or jog?
Selector switch
What type of motor needs a boost to get rolling?
Single phase capacitor motor
IEC
International electro-technical commission?
Voltage has to be supplied to what component to close the main movable tips to supply power to the motor?
Coil
Stop button is normally?
Closed
Start button is normally
Open
Draw a Y configuration drawing
The initial surge of power going into a motor until it gets up to speed
In rush
Normally closed tips
Normally open tips
Capacitor is discharged how?
Being shorted
Central location that distributes power throughout your home?
Load center
What is used to protect a control transformer
Control fuse
The low voltage side of the transformer
Secondary
What is used to make the motor run?
Motor starter
X2 is always what on a control transformer?
Neutral
FLA stands for?
Full load amps
An e-stop is what type of button?
Maintained
Megger should read what from phase to ground and a new motor?
550 MegaOhms
What can be mounted in any type of box for easy connections?
Terminal strip
Phase to phase on a good motor should be read?
0.0 ohms
On a regular meter you should read what from phase to ground?
O/L