Driving and Controls

Question 1

First Gear Range : Use this range when pulling through ___, when maneuvering in tight spaces, or while driving ____.

Answer 1

mud and deep snow / up or down grades

Question 2

Lower ranges provide greater ___ for going downgrades (the lower the range, the greater the braking effect).

Answer 2

engine braking

Question 3

High gear ___ may be used for vehicle speeds in excess of ____ and may only be activated by pressing the MODE button.

Answer 3

(5) / 46 mph

Question 4

Gear 1

Answer 4

2100 RPM / 14 MPH

Question 5

Gear 2

Answer 5

2100 RPM / 27 MPH

Question 6

Gear 3

Answer 6

2100 RPM / 36 MPH

Question 7

Gear 4

Answer 7

2100 RPM / 46 MPH

Question 8

Gear 5

Answer 8

2100 RPM / 69 MPH

Question 9

If the engine fails to start within ___, release the starter button and allow the starting motor to cool for approximately ___ before trying again.

Answer 9

15 seconds

Question 10

If the engine fails to start after ___ attempts, an inspection should be made to determine the cause.

Answer 10

four

Question 11

A good indicator that all of the moving parts are getting lubrication is when the oil pressure gauge registers pressure (____) at idle speed.

Answer 11

at least 37 psi

Question 12

Stopping Engine : Allow the engine to idle for ___. This allows the turbocharger adequate time to slow and cool down.

Answer 12

four or five minutes

Question 13

Try not to shut down

the engine unless coolant temperature is ___ or less.

Answer 13

195º

Question 14

In the event air brake system pressure drops below approximately ____ an audible alarm will sound, and if the pressure drops below approximately ____, the rear brakes will lock up.

Answer 14

85 psi / 60 psi

Question 15

Use extreme caution when operating the vehicle with either air brake section charged to less than ___ or property or personal injury could result.

Answer 15

60 psi

Question 16

If air pressure is reduced to approximately ___ in both systems, the spring brake valve will automatically apply.

Answer 16

40-60 psi

Question 17

The Total System Manager will check voltage every___ and will only turn OFF one accessory at each voltage check.

Answer 17

30 seconds

Question 18

Once the Total System Manager starts to turn OFF accessories, the first accessory de-activated will be turned OFF for at least___ before Total System Manager will turn anything back on again.

Answer 18

5 minutes

Question 19

In addition to being OFF for at least 5 minutes, the Total System Manager must register at least ___ of acceptable voltage during this 5-minute interval before it will start to turn accessories back on.

Answer 19

1 minute

Question 20

In the event of electrical demand exceeding electrical supply, the first electrical load to be shed will be the air conditioning. This component will be turned off when electrical system voltage drops below ___

Answer 20

12.2 Volts.