Discrepencies Flashcards
Disabling engine parameters
R/G psi below 230psi engaged
Below 58psi disengaged
MDE L/O psi below 49psi at cruising
MDE temp below 140 or above 212 degrees F
Fails to start
Disabling
Uncontrollable overheat
Disabling
Metallic non-metallic noise metal on metal fuel knock bearing clicking
Disabling
Fuel oil dilution 2.5% or above
Disabling
Water in engine lube oil
Disabling
Lube oil in jacket water
disabling
Red gear fails to engage disengage
Disabling
Continuous electrical breaker trip
Disabling
Engine motor mount hardware loose or missing
Disabling
Excessive shaft seal leak while rotating trickle or steady stream
While not rotating more than 15 drops per minute
Disabling
No electronic means of signal in distress
Disabling
Fuel or lube oil dripping on a hot surface greater than 400°F even if covered by insulation
Disabling
Electrical arcing and sparking
Disabling
Inoperative open closed Seachest valve, fuel shut off valve, engine shutdown dampener, or engine room air damper
Disabling
Maximum RPM underload less than 2100 RPM
Restrictive
Engine water tip below 212 and above 192°F
Restrictive
Leaks more than 15 drops per minute Jacket water Raw water Lube oil Hydraulic oil Reduction gear oil
Restrictive
Fuel dripping onto a surface which is not a hot one drop within 10 minutes
Restrictive
Bilge pump’s and water pump activation sensors in operative
Restrictive
Any detectable exhaust leaks
Restrictive
Missing exhaust lagging or system blankets
Restrictive
Missing or loose shafting bolts
Restrictive
P6 pump kit incomplete in operative or missing
Restrictive