Conventional And Fighter Jet Engine Construction Flashcards
Power to drive the AGB on the F108 engine is transmitted from the?
Accessory major module
On the F108 engine, what does the IGB contain?
A horizontal bevel gear, a radial bevel gear, and a core engine thrust bearing (No. 3 [ball])
On the F108 engine, the purpose of the HPT nozzle assembly is to accelerate the energy from the combustion gases to drive the?
HPT rotor
Which turbine stages on an F100-PW-220 engined drive the front compressor?
Third and fourth
What is one advantage of a modular engine?
Entire engines are not withheld from service
External flanges on the F100 are referred to by?
Letter designations
On an F100-PW-220 engine, why are the leading edge vanes hollow?
So anti-icing air can flow through them
The F100-PW-220 core module remote splitter is contained in the?
Compressor intermediate case
On the F100-PW-220 engine, where is the No. 2 bearing housed?
Compressor intermediate case
On an F100-PW-220 engine, the front compressor drive shaft is connected to the front compressor rotor by?
The turbine drive shaft coupling
Which component on an F100-PW-220 engine sends a signal to drive the primary actuator flexible shaft?
Convergent exhaust nozzle control (CENC)
On an F100-PW-220 engine, the gearbox module is driven by the rear compressor through?
A gearbox drive shaft
How many stages are in the inlet fan module in the F100-PW-220 engine?
Three
Where is the No. 2 bearing located in the F100-PW-220 engine?
Intermediate case
What are the parts of the core module of a F100-PW-220 engine?
Intermediate case, HPC, diffuser case, combustor, HPT
