CJ3 Systems tests/ profiles/ annunciators

Question 1

Name the only “amber” condition that causes a Master Warning Light to illuminate.

Answer 1

Failure of both generators warrants a Master Warning Annunciator

Question 2

What conditions warrant an abort of the start sequence?

Answer 2

1. Rapidly rising ITT approaching 1000C 2. No ITT rise in 10sec 3. No N1 rotation by 25% N2

Question 3

Generator System Check

Answer 3

1. L GEN OFF 2. R GEN OFF 3. L GEN - GEN 4. R GEN - GEN 5. Battery - OFF 6. Battery - BATT

Question 4

Elevator Trim System Check

Answer 4

1. Trim Down, Disconnect 2. Trim Up, Disconnect 3. Operate Each Half of the switch independently ensuring no movement 4. Repeat for opposite yoke controls 5. Re-trim for takeoff

Question 5

Flap System Test

Answer 5

1. Ground flaps - Speed Brakes Deployed 2. Throttles - >85% N2, Speed brakes retract, flaps >35 illuminates 3. Throttles - Idle, Flaps >35 extinguishes, Speed brakes extend 4. Flaps - Takeoff and approach

Question 6

Rudder Bias System Test

Answer 6

1. Left Throttle - >70% N1, Verify left pedal movement, retard throttle 2. Right Throttle - >70%N1, Verify right pedal movement, retard throttle

Question 7

All Engine Go Around

Answer 7

1. Throttles - To Detent
2. Pitch - +7.5º (go-around mode)
3. Flaps - Takeoff and Approach
4. Climb Speed - Vapp
5. Gear - UP (At positive rate)
6. Flaps - UP
7. Throttles - As Required