Brainscape's Knowledge GenomeTM

Browse over 1 million classes created by top students, professors, publishers, and experts.


See full index

BM1 SWE > CIM M10360.3D COATINGS AND COLOR MANUAL > Flashcards

CIM M10360.3D COATINGS AND COLOR MANUAL Flashcards

1
Q

Interior repainting shall normally not be required more often than once every ___ years?

A

Three

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
2
Q

Exterior steel surfaces on cutters and boats above the main deck shall not normally be top coated more often than every ____ years.

A

Two

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
3
Q

Exteriors of hulls above the boot-top should not normally be coated more often than ______.

A

Every year

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
4
Q

The anti corrosion primer used with ablative paints should remain in place for the life of the paint. (Approximately _____ years)

A

9-12

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
5
Q

The various non-skid resistant coating system used for weather decks should provide about ____ years of service.

A

3 - 6

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
6
Q

Ships work force is authorized to spot repair flight decks up to _______ square feet in order to control underlying corrosion in accordance with guidelines set out in reference (c).

A

Fifty (50)

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
7
Q

The detachable links between shots, excluding the detachable link for the 5 fathom connecting section, will be painted in the following pattern starting at the anchor end and working inboard, repeating the pattern as necessary.

A

15 fathom-first shot-red detachable link
30 fathom-second shot-white detachable link
45 fathom-third shot-blue detachable link

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
8
Q

The first link on each side of the 15 fathom detachable link shall be painted _______.

A

White

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
9
Q

The same pattern of marking detachable links shall be continued up to the next to last inboard shot. All of the links in the next to last inboard shot shall be painted ______, and all of the links in the last inboard shot shall be painted ______.

A

Yellow , Red

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
10
Q

____ inch wide red warning lines shall be painted on the deck to designate Radio Frequency Radiation Hazard Areas.

A

Four

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
11
Q

All deck machinery including winches, capstans, davits, and cranes, along with their associated appendages such as booms, cradles, frames, equipment safety bumpers, controls and control stands shall be painted __________.

A

Spar (10371)

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
12
Q

Working surfaces in contact with wire rope or synthetic lines may be coated with gray or green-gray ____________.

A

Inorganic Zinc

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
13
Q

Aft hand rails on the 49 BUSL shall be painted ________.

A

Black

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
14
Q

The foundations of all gun mounts, mortars, launchers, and gun directors shall be painted _______________________________ on which they are mounted.

A

The same color as the deck

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
15
Q

All open gun mounts and mortars shall be painted ________.

A

Black

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
16
Q

On Ordnance Equipment, film thickness tolerance must be maintained to avoid interference with radar transmission. Dry film thickness shall not exceed ___ mils total.

A

Six

17
Q

Spuds shall be flat black or black. A red ____inch wide band shall be painted completely around the spud ____ feet from the top.

A

6 in. 6ft.

18
Q

For piping systems, lettering shall be ____ high for two inch or larger outside diameter bare pipe or insulation.

A

One inch

19
Q

Direction of flow shall be indicated by an arrow ____ inches long pointing away from the lettering.

A

Three inches

20
Q

Paints shall contain no more than ________ % lead by weight.

A

0.009%

21
Q

(Volatile Organic Compounds)

VOC content limit for anti-fouling bottom paint is _____ grams/liters.

VOC content limit for all other marine paints is ____ grams/liters.

A
  1. 400
  2. 340
22
Q

Check the adhesion on oil based and water based paints. Cut a series of cross-hatched lines into the dried paint with a razor blade down to the base metal. Then apply and remove a strip of duct tape. If ____% of the paint stays in place, it is suitable for use.

A

90%

23
Q

Check the adhesion of epoxy paints. Tap the dried paint film with a hammer _________ times with enough force to drive a nail 3/4 inch into a piece of pine. If the paint does not stay intact, it is not suitable for use.

A

10 to 20 times

24
Q

Do not extend shelf life on paints with; improperly sealed or corroded containers, two part epoxy paints stored above ___ degrees, water based paints which have been frozen, or oil based paints which do not mix to a smooth consistency.

A

140 degrees Fahrenheit

25
Q

Most two-part epoxies can be properly stored in ambient temperature conditions and remain functional for up to ___ years.

A

10 years

26
Q

Water based and oil based paints, can be stored at ambient conditions for up to ____ years.

A

3 to 5 years

27
Q

Previously opened cans of water based and oil based paints are usually NOT suitable if stored for longer than ______.

A

One year

28
Q

Previously opened cans of unmixed two-part epoxy paint in good condition may still be good after _______ years of storage.

A

3 to 4 years

BM1 SWE (16 decks)

Brainscape helps you reach your goals faster, through stronger study habits.
© 2024 Bold Learning Solutions. Terms and Conditions