Checklists and flows Flashcards
1
Q
Start Procedure Flow
A
Throttle - 1/4 Open Starter - Engage Throttle - 1000RPM Mixture - Lean Oil Press. - Green Ammeter - Check Fuel Selectors - Crossfeed Fuel Selectors - On
2
Q
Taxi Flow
A
Brakes - Test
Instruments - Check
Run-up Positioning - Into wind
3
Q
Run-Up Flow
A
Throttles - 1000 Man. Press Lines - Drain Propellers - Feather Check (-300 Max) Mixtures - Full Fwd Propellers - Full Fwd Throttles - 1900 Propellers - Gov. Check Alt. Air - Check Magnetos - Check (150drop/50diff max) Engine Instruments - Check Alternator Output - Check Vacuum Gauge - 4.5-5.2 Throttles - 1000
4
Q
Pre-Takeoff Flow
A
Takeoff Briefing - Complete
Lights - All On
Camera - Transponder Alt
Action - Note Takeoff Time/Base-Final Check
5
Q
Normal Takeoff Flow
A
Trim - Set Flaps - Up Rotate - 85 Gear - Up with Pos. Rate Landing Light - Off Climb-out - 100 abv 1000 Databox - On
6
Q
Short Field Takeoff Flow
A
Flaps - Up or 25
Speed - 71 till clear then 76/82(flaps up)
Gear - Up with Pos. Rate
Landing Light - Off
7
Q
Climb Flow
A
Gear - Up Landing Light - Off Throttles - 31.5"-35" Propeller - 2450 Airspeed - 102 > 500'
8
Q
Cruise Flow
A
Mixture - As Req. Throttles - As Req. Props - As Req. Altimeter/DG - Set Cowl Flaps - As Req.
9
Q
Landing Flow
A
C - Cowl Flaps - Set G - Gas - On U - Gear - Down/Locked M - Mixture - Set P - Props - Full Forward S - Seats/Seat Belts - Locked
10
Q
Go-Around Flow
A
Throttle - Full Flaps - Retract to 25 Airspeed - >=89 Gear - Up Flaps - Retract Incrementally
11
Q
After Landing Flow/Checklist
A
Trim - Set Takeoff Flaps - Up Heater Switch - Fan (if used) Ldg/Strobe Lights - Off Transponder - Standby Cowl Flaps - Open Mixtures - Lean
12
Q
Burner Check
A
Starter/Fuel - On
After 10 sec - Fuel Off
Starter - Off
