charging system testing and service

Question 1

symptoms of an overcharged battery

Answer 1

bright lights

Question 2

poor of loose condition alternator belt causes

Answer 2

undercharged battery

Question 3

belt glazing is caused by heat friction when a loose belt slip on pulleys ? t or f

Answer 3

true

\

Question 4

if a belt is to tight what happens

Answer 4

premature wear

alternator bearing and pulley damage

Question 5

unwanted high resistance in insulated and ground connections causes

Answer 5

increased voltage lose

Question 6

unwanted highresistance at terminals can be reduced by

Answer 6

tightening and cleaning terminals

Question 7

to restore the rotors residual magnetism you must

Answer 7

momentarily connect a jumper from the alternators + terminal to the R terminal

Question 8

alternator pulley must be held with what during removal of the rotor shaft

Answer 8

strap wrench

Question 9

DMM provides ____required to turn on diodes when connected in forward bias

Answer 9

voltage

Question 10

diode test provides the indication of?

Answer 10

forward bias drop voltage

Question 11

the rotor windings can be checked for ___by connecting a battery and ammeter in series with the surfaces of the two slip rings

Answer 11

short circuits

Question 12

if rotor slip rings are dirty they can be cleaned with what ?

Answer 12

400 grit sandpaper

Question 13

if brushes and brush holders are reused, the wear patterns of the brush must be matched with the ?

Answer 13

radius of the slip rings

Question 14

a capacitor can be tested with a ?

Answer 14

capacitor tester

Question 15

what dissolves stator and rotor windings insulating layers

Answer 15

petroleum based solvents

Question 16

to protect the aluminum housing always press the ___and___onto the supported rotor assy

Answer 16

drive end bearing and bearing assy

Question 17

false voltage conditions can t be caused by

Answer 17

loose of corroded electrical connections