Chapter 9 - Clearances Flashcards
Fill in the blanks:
Obtain a readback in sufficient ______ that clearly indicates pilot’s __________ of and __________ with all ATC ________, including _________ _________ , __________ and ________ which are transmitted by _____.
detail understanding complicance clearances conditional clearances instructions, information voice
v39.1_9.2.2.12
What are the 8 key elements for the readback required for ATC clearances, instructions and information?
What is the note for pilot read back of expected runways?
a) __ _____ ______ instructions;
b) any ____ and ______ point specified in a ____ clearance;
c) any clearances or instructions to ___ ____ of, ____, ____ on, ___ __ on, ___, ___-___ from, ____, ___ or _______ on, any runway or HLS;
d) an _______ runway or HLS;
e) any _______ clearance;
f) _______ settings directed to _______ aircraft, ____ and ____ _____ ________ instructions;
g) ___ ____ and ___ ___ ____ codes; and
h) ____ instructions, direction of ___ , ______ and ____ instructions.
Note: Pilots are ___ _______ to ____ ____ an _______ of the runway to be used.
h) navigation
a) en route holding;
b) route, holding, taxi;
c) hold short of, enter, land on, line up on, wait, take-off from, cross, taxi or backtrack on
d) assigned;
e) approach;
f) settings , aircraft, radio , radio navaid frequency;
g) SSR codes , data link logon ;
h) level, turn, heading, speed.
Note: not required, read back, expectation
v39.1_9.2.2.12.2
Complete the missing from the following:
3 Indentificaion Procedures:
Establish identification by one of the following procedures:
a) correlate an ____________ _____ with an aircraft’s ___ ________ system _______ _______ provided the correlation is consistent with the aircraft’s _______ _______;
b) ______ of _________;
c) observe ________ with an instruction to:
i) operate the _______ ________ _________ (_ _ _);
ii) change to a _______ ___ ____; or
iii) transmit _______ _______; or
d) correlate an observed ________ _______ symbol with _________ _________ executed by a/an _______ aircraft which _________ __________ to that effect, provided that _________ is __________ within _ NM of the _____ sensor.
a) alpha-numeric label ATS surveillance system position symbol expected position b) transfer, identifcation c) compliance i) Special Position Identification (SPI) ii) specific SSR code iii) ADS-B IDENT d) radar position manoeuvres currently departing acknowledged instruction identification, established 3 radar
v39.1_9.7.2.4
Complete the missing from the following:
3 Additional Identification Procedures - Primary Surveillance Radar (PSR):
a) Correlate a particular ______ ______ ______ with an aircraft reporting its _____ _____, or _____ and ______ ____, a point shown on the _____ _____, provided the ____ of the _____ ______ _______ is consistent with the aircraft ___ or ______ ______;
b) Correlate an observed _____ ______ ______ with an aircraft which is known to have ______, provided that the identification is established within ____ from the ___ of the ______ ____; or
c) ascertain the aircraft _____, if required, and following a period of track observation:
i) instruct the pilot to execute one or more ______ of ______ of ___ _______ or ____ and correlate the movements with the aircraft’s ________ _______ of the _______ given; or
ii) correlate the _________ of a particular _____ ______ _____ with the _______ _______ of an aircraft.
a) radar position symbol position over bearing distance from situation display track radar position symbol path reported heading b) radar position symbol departed 1NM end runway used c) heading i) changes, heading, 30 degrees, more, acknowledged execution, instructions ii) movements, radar position symbol, reported manoeuvres
v39.1_9.7.2.5
Complete the missing from the following:
Identification Conditions - Primary Surveillance Radar (PSR):
a) verify that the ________ of not more than ____ radar position symbol correspond with those of the aircraft;
b) ensure that the manoeuvre(s) will not carry the aircraft _____ the coverage of the ____ or the _______ _______; and
c) allow for equipment _______ in the ________ position and in the ________ ______ position symbol
a) movements one b) outside radar situation display c) tolerances reported observed radar
v39.1_9.7.2.5.1
Complete the missing:
Methods of verifying accuracy of pressure altitude-derived information.
Verify by simultaneous comparison with:
a) altimeter-derived level information received from the ____ aircraft by ___________; or
b) the aerodrome ________ during the _____ ____, provided that the level information __________ indicates a ______ ______ after take-off.
a) same radiotelephony b) elevation take-off roll subsequently positive climb
v39.1_9.7.5.4
Transfer of Identification.
When relaying the identificaiton of an aircraft from one Controller to another, and transfer of control is not effected, the relaying Controller advises that the aircraft is:
“____ _______”
and the receiving Controller acknowledges identifcation by replying with the
_______ __ ___ ______.
“FOR IDENT”
callsign of the aircraft
v39.1_9.7.6.1
Transfer of Identifcation.
Methods
List 8 methods to effect transfer of identification:
Clues:
a) designation of the ______ _______ by _________ means, provided that only ___ position is indicated and there is no doubt as to the _____ ________;
b) notification of the aircraft’s discrete ___ ____ or aircraft ______;
c) notification that the aircraft is ___ ____ _ equipped with an aircraft ________ ______ when ___ ____ _ coverage is available;
d) notification that the aircraft is _____ equipped with an ____ feature when _____ coverage is available;
e) ______ ______ (______ ____ ___ _____) of the position symbol on a ______ or an _______ situation display. Be aware of errors resulting from _____ effects;
f) designation of the position symbol by _______ __, or in terms of _______ and ______ from, a _________ position or _________ facility ________ indicated on both _________ _______ (see Clause 9.7.6.1.2);
g) instruct the aircraft to _____ ___ ____ and the _____ is observed by the _______ ________; or
h) instruct the aircraft to ‘________ ______’ or ‘________ ______ ______’ and the ______ is observed by the ________ ________.
a) position symbol automated one correct identification; b) SSR code, address; c) SSR Mode S, identification feature, SSR Mode S; d) ADS-B , ACID, ADS-B; e) direct designation (pointing with the finger) shared adjacent parallax; f) reference to, bearing distance geographical navigational accurately situational displays; g) change SSR code change , accepting Controller; h) 'SQUAWK IDENT' , 'TRANSMIT ADS-B IDENT' change , accepting Controller.
v39.1_9.7.6.1.1
Complete the missing on the following 5 scenarios:
Providing Position Information
Provide position information when required by circumstances or when requested by another ATC unit. Pass the information with reference to:
a) a _____ or ____ and _______ from any _______ point (______ may be _______ or as points of a ______ );
b) a ___-_____ _________ position;
c) a _______ to runway _______ ____ if the aircraft is on ____ _______;
d) a _______ to runway _______ ____ as _____ ____ to run; or
e) _______ and _______ from the _____ ___ of an ___ _____.
a) bearing, track, distance significant, (bearing, magnetic, compass)
b) well-known, geographical
c) distance, touchdown point, final approach
d) distance, touchdown point, track miles
e) distance, direction, centre line, ATS route
v39.1_9.7.8.1
Complete the missing on the following 8 scenarios:
When to Provide Position Information
Advise an aircraft provided with an ATS surveillance service of its position:
a) __ ________, unless _________ is established:
i) based on a pilot’s _____ of the aircraft’s ______;
ii) within ___ of the runway on ______ , if the _______ position on the ______ display is consistent with the aircraft’s ____ of _______;
iii) by use of ____ aircraft identification, ___ ____ _ aircraft identification or assigned _____ __ ____ if the location of the ______ ______ ______ is consistent with the current ____ ____ of the aircraft; or
iv) by _____ of _________;
b) ____ commencement of ______ by ______ control as soon as a distance to run to ________ becomes ______ ;
c) when a pilot requests ______ _________;
d) when an ______ aircraft’s ______ position differs significantly from its ______ position.
e) when an ______ aircraft is _______ to have _______ from its previously _______ or ______ route;
f) when the aircraft is ______ its own ______ after _______;
g) when a regular ____ ______ is used to vector an aircraft onto the ____ ________ path, at least ____ on each ___; and
h) when provided with ______ for a _____-__ approach at least once before commencement of ____ _______.
a) on identification, identification
i) report, position
ii) departure, observed, situation, time, departure
iii) ADS-B, SSR Mode S, discrete SSR codes,
observed position symbol, flight plan
iv) transfer, identification
b) after, approach, touchdown, evident
c) position information
d) identified, reported, observed
e) identified, observed, deviated, approved, advised
f) resuming, navigation, vectoring
g) circuit pattern, final approach, once, leg
h) vectors, straight-in, final approach
v39.1_9.7.8.2
