Chapter 2 Flashcards
In a line diagram, the power circuit is shown in ______ lines than the rest of the diagram.
heavier
A ______ diagram is used to show the relationship between circuits and their corresponding components but not the actual location of the components.
line
A pushbutton is an example of a(n) ________ control switch.
manual
A float switch is an example of a(n) ________ control switch.
automatic
A line diagram is always read from ______ to_____.
L1-L2
A _____ is used for remote control of devices.
Solenoid, Magnetic starter, contactor
In a line diagram, the overload contacts are show as connected between the motor and ________.
L2
A(n) ________ is a device that converts various forms of energy into electricity.
power source
A(n) _________ is an electrical device which consists of a frame, plunger, and coil and is used to create a push or pull action.
solenoids
A(n) ________ is an electrical device which consists of a frame, plunger, and coil and is used to open and close a set of contacts in addition to providing overloads protection.
Magnetic motor starter
_________ contact are used in the control circuit to form an electrical holding circuit.
Normally open
A(n) ________ diagram is a diagram that shows the electrical connections and function of a specific circuit arrangement with graphic symbols.
schematic
For consistency, the ______ symbol is always drawn in a line diagram after the motor.
OL’s
A(n) _________ is an assemblage of conductors and electrical devices through which current flows.
electrical circuit
______ diagrams show, as closely as possible, the actual location of each component in a circuit.
wiring
