Chapter 11-12 Flashcards
T/F : Do not write on plans unless you are permitted to as most plans must be turned in at the end of a job.
True
The typical scale used in the US on Civil (non Federal goverment) plot plans is
Engineer Scale
T/F The most significant difference between engineers scales and architect scales are that the engineer scales measures in decimal feet and the architect scale measures in feet and inches
True
T/F: The length and direction of a property line is designated with a compass reading in degrees, minutes, and seconds, followed by a distance in decimal feet
True
T/F: Contour lines never meet, end, or cross except in the case of an overhanging cliff.
True
T/F: Contour lines must be drawn so that the ground higher than the contour line is always on the same side of the contour.
True
Proposed contour lines should always be drawn as
dashed lines
Convert 33.455 degrees to degrees-minutes-seconds
whole number: 33
0.455*60 = 27.3
0.3*60 = 18
33 degrees 27 minutes 18 seconds
How much waste to account for in concrete orders
10%
