CH.7 Installing and operating Cisco LAN Switches

Question 1

In what modes can you execute the command “show mac address-table”?

a. user mode
b. enable mode
c. global configuration mode
d. Interface configuration mode

Answer 1

a. user mode

b. enable mode

Question 2

In which of the following modes of the CLI could you use the command “reload” to reboot the switch?

a. User mode
b. Enable mode
c. Global configuration mode
d. Interface configuration mode

Answer 2

b. Enable mode

Question 3

Which of the following is a difference between Telnet and SSH as supported by a Cisco switch?

a. SSH encrypts the passwords used at login,but not other traffic,Telnet encrypts nothing.
b. SSH encrypts all data exchange,including login passwords; Telnet encrypts nothing.
c. Telnet is used from Microsoft operating systems, and SSH is used from UNIX and Linux operating systems
d. Telnet encrypts only password exchanges; SSH encrypts all data exchanges.

Answer 3

b. SSH encrypts all data exchange,including login passwords; Telnet encrypts nothing.

Question 4

4. What type of switch memory is used to store the configuration used by the switch when
it is up and working?
a. RAM
b. ROM
c. Flash
d. NVRAM
e. Bubble

Answer 4

a. RAM

Question 5

5. What command copies the configuration from RAM into NVRAM?
   a. copy running-config tftp
   b. copy tftp running-config
   c. copy running-config start-up-config
   d. copy start-up-config running-config
   e. copy startup-config running-config
   f. copy running-config startup-config

Answer 5

f. copy running-config startup-config

Question 6

A switch user is currently in console line mode. Which of the following would place the user in enable mode? (choose two)

a. using the exit command once
b. using the end command once
c. pressing the Control-Z key sequence once
d. using the quit command

Answer 6

b. using the end command once

c. pressing the Control-Z key sequence once