Ch11 operating fire pumps Flashcards

1
Q

Once the driver/operator does exit the cab, the next step, in all cases except when apparatus is used for pump-n-roll-operations, should be to?

A

chock the apparatus wheels

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
2
Q

the procedure for making the pump operational varies depending on the blank and the blank?

A

type of pump drive, manufactuerer of the apparatus

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
3
Q

midship pumps require that both the blank and blank be in gear for operation

A

pump, drive transmission

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
4
Q

of the three possible types of water supply for the fire pump, most drivers operate solely from the blank at the vast majority of incidents

A

onboard water tank

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
5
Q

when using 2.5 inch or 3 inch hoselines t supply the pumper directly off hydrant pressure, it is recommended that the lines be no longer than blank feet

A

300

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
6
Q

the maximum amount of vacuum that most pumps develop is approximately blank inches of mercury

A

22

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
7
Q

blank can be described as that condition where, in theory, water is being discharged from the pump faster than it is coming in

A

cavitation

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
8
Q

cavitation often results when a pump has been equipped with inadequate piping from the blank

A

water tank

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
9
Q

The first consideration in establishing a successful drating operation is?

A

selecting the site

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
10
Q

The most important factor in the choice of the draft site is the ?

A

amount of water available

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
11
Q

Water that is below blank degrees or above blank degrees may adversely impact the pump’s ability to reach capacity

A

35, 90

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
12
Q

At 20 feet of lift, the amount of water that can be supplied is only about blank percent of the rated capacity of the pump

A

60

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
13
Q

if a blank type intake valve is normally connected to the pump intake, it is SOP in some departments to remove it before connecting the intake hose to the apparatus

A

butterfly

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
14
Q

The entire priming action typically requires blank to blank seconds from start to finish, but when using no more than 20 feet of hard intake hose lifting a maximum of 10 vertical feet it should not take more than 30 seconds(45 seconds in pumps larger than 1,250 gpm) to accomplish

A

10-15

How well did you know this?
1
Not at all
2
3
4
5
Perfectly