ch 1 Flashcards
Approximately what percentage of the information needed to fight a fire in a building can be ascertained prior to the
incident?
p. 3
A.) 95%
B.) 90%
C.) 80%
D.) 85%
B.) 90%
What type of aid should be established to increase safety
and operational capability and effectiveness?
p. 6
A.) Automatic
B.) Response
C.) Exclusive
D.) Mutual
A.) Automatic
What type of buildings change the rules of the game?
- Lightweight buildings
- Large area structures
- Vacant buildings
What represent where the fire is going?
p. 17
A.) Parent fire
B.) Exposures
C.) Extent
D.) Location
*B.) Exposures
Which is the most important size-up factor?
p. 21
A.) Time
B.) Occupancy
C.) Location and extent
D.) Area and height
C.) Location and extent
Where may be the only possible location to ladder the building when the fire occurs on a steep hill?
p. 12
A.) Rear
B.) Must use an aerial
C.) Sides
D.) Front
C.) Sides
What is NOT a correct statement about hazardous materials
operations?
p. 24
A.) Move close enough to identify the product
B.) Isolate the area
C.) Control ignition sources
D.) Request the experts and support them
A.) Move close enough to identify the product
Control of any fire begins and ends with the control of the ______?
p. 1
A.) Fire source
B.) Weather
C.) Fireground
D.) Training
*C.) Fireground
Where can a radio relay be used to effectively
communication information from dispatch to Command?
p. 19
A.) Tunnel
B.) Elevator
C.) High-rise
D.) Rural
A.) Tunnel
What must be in place or else the game is over before it begins in the fire service?
Water supply
Where may be the only possible location to ladder the building when the fire occurs on a steep hill?
Sides
Which type of building is one that does NOT change the rules of the game?
Heavy timber structures
What represents where the fire is going?
Exposures
What does control of any fire begin and end with the control over?
Fireground
Which is the most important size-up
Location and extent
What is NOT a correct statement about hazardous materials operations?
A.) Move close enough to identify the product
B.) Isolate the area
C.) Control ignition sources
D.) Request the experts and support them
A
Attempt to identify the product, if it can be safely done from a distance.
Page 24
What type of aid should be established to increase safety and operational capability and effectiveness?
Automatic