CDL General Knowledge Flashcards
Next
Step three of the seven step inspection method is start engine and inspect inside the cab. This step involves each of the following tasks except?
Starting the engine, then putting the gearshift in neutral
A top heavy load is dangerous because it can cause
Damage to the axles were staring.
A rollover on a curve
A roll over if you swerve around a hazard.
I
The aggregate working load limit of your cargo tiedowns must be at least ____________the weight of the cargo?
One half
What is the gross vehicle weight (GVW) ?
The total weight of a single vehicle and it slowed
An A: B: C: type fire extinguisher is designed to work on which type of fires Wood, paper, Cloth. Gasoline. Electrical Actual answer (all of the above)
Which of these is not part of the seven step inspection method?
Answer step 3. Do a walk around inspection
What three things related to cargo are the drivers responsibility?
Inspecting the cargo, recognizing overload, I am properly securing the cargo.
Hydroplaning,
is more likely to happen will try her pressure is low
Under loaded front axle can cause
Poor traction and damage to the tires. Too much play in the steering well.
Actual answer both of the above
Which of these statements is true about causes of vehicle fires?
Poor trailer ventilation can cause flammable cargo to catch fire
Which of the following should you not do in the event of hydraulic brake failure?
Answer shift up
What is the main difference between a cargo tank in a portable tank? Answer all of the above
Permanent attachment Vs temporary attachment
Whether the name of the owner or lessee must be shown
Being field on the vehicle versus being off the vehicle
Which of the following is true about a dual air brake system? Answer all of the above
It uses a single set of brake controllers.
one system is called the primary system the other is called secondary system.
Usually, one system operates the front axle and the other system operates the rear axle
The purpose of supply pressure gauge is?
To tell you how much air is in the tank.
Which of the following is not part of the breaking process when driving a tractor trailer combination vehicle with an anti-lock brake system (ABS) ?
Stupid question stupid answer
You should drive more quickly so that you will be able to keep the trailer and tractor straight
The modulating control valve allows you to control the?
Answer spring break
Excessive use of the service brake results in overheating, which can lead to?
Answer expansion of the brake drums
Airbrake equipped vehicles have?
Answer an air supply pressure gauge
You want to hook your combination to a second trailer that has no spring breaks. To do this without wheel chocks, you should?
Answer supply air to the trailer air system with the tractor and then disconnect the emergency line
Liquid tight separators between compartment inside tanks or called? Answer bulkheads
What structure supporting the fifth wheel skid plate should be checked for cracks or breaks?
Answer platform
If worn, what can cause excessive heat buildup from a reduced ability to absorb and dissipate heat, possibly leading to loss of break response?
Answer brake drum/linings
What, if loose or missing, may cause movement between the frame in the fifth wheel assembly?
Answer locking pins
Trucks and buses are subject to certain laws, restrictions, and regulations. Which of these statements are true?
Answer laws and restrictions can vary from place to place
What should be fully engaged with no missing pins in the sliding mechanism of the sliding fifth wheel? Answer locking pin
You were looking for puddles on the ground and dripping fluid on the underside of the engine or transmission what are you looking for? Answer leaks
The liquid in a tank with baffles and still have what kind of search?
Answer side to side
You were hauling hazardous materials, the road crossing is ahead of you. When you stop for the Crossing, you can stop within 50 feet of the nearest rail? Answer 50 feet of the nearest wheel