BA Flashcards
5 emergency frequencies
VHF-AM (Tower) 121.5 MHz
VHF-FM (CG stations) 156.8 MHz
UHF (Military) 243.0 MHz
HF (Long Range) 4125 KHz
HF ALE - All
Cabin door and cabin window speed for opening
Max is 70 Kts
In an electrical fire, what happens when you kill A/C power, You’ll lose what? And what happens to your torque?
Lose AFCS, ICS, and Flight instruments
Engine and inlet anti ice valves will open automatically resulting in a loss of about 18% available torque.
What should APU accumulator pressure be?
2700 to 3000 psi
Engine run limits: what should TGT be before inducing water?
80 degrees C
151 degrees C when CBs are pulled
Engine run limits: NG should increase to what percentage within 6 secs?
14 percent
Engine run limits: oil pressure and light off(audible tone) should increase within how many seconds?
30 seconds for both
Engine run limits: starter should dropout at what percentage of NG?
52-65 percent
Engine run in IDLE: What should NGs be?
67 +-1
Should match within 3 percent of opposite engine
Engine run limits in IDLE: what should oil pressure be?
22-55 psi
What are the starter duty cycles?
Any temperature(motoring):
On 2 min/off 5 min
On 2 min/off 30 min
Engine wash limits: when water is induced, what is the NG range?
What is NG before water is induced?
NG shall be between 16-24 percent
Water induced when NGs are stable. No lower than 24 NG
Hydraulic system: selector valve placements and stowed position?
Out 1: pump 1
Out 2: pump 2
Out 3: back up pump and APU accumulator for maintenance
Out 4: rotor brake and stowed position
Hydraulic systems: what is capacity for hand pump reservoir:
1.3 quarts
Hydraulic systems: what is capacity for the hydraulic pumps?
When does low level light come on for pumps, capacity and percentage?
All three pumps: 1 US Qt full)
0.52 which is 60%
Hydraulic systems: what is the fluid name?
Mil-prf-83282
No substitutes
What are the primary fuels allowed?
Jp 5, jp 4, jet A, and jp 8
Stop refueling if the main tank pressure gauge reaches what psi?
2 psi
What is the percentage of fsii required in fuel?
.07-.15% by volume
What is main tire pressure and cut limit?
95-100 psi
4/32”
What is tail tire pressure? What is cut limit? What is allowable tire slippage?
78-83
3/32”
1/4”
What is the minimum pressure on the rotor brake gauge?
What is the minimum measurement for brake wear indicator pins?
450 psi
3/16”
What are the fuselage tie down rings rated for?
12,500 lbs
How many knots do you need to tie down blades?
What must be done when knots are above 20?
45 kts
Rotor brake on
Aircraft parked into wind
APU: how long after shutdown do you check oil level?
What is primary oil to be used?
What is secondary oil to be used?
What is cold weather oil to be used? What is air temperature?
Where should oil level be?
What is capacity?
1 hour after shutdown
Mobil jet 254
MIL-PRF-23699
MIL-PRF-7808 (-25C or below)
1/8” above add line
3 quarts
Engines: how long after shutdown should you check oil level?
What is primary oil to be used?
What is secondary oil to be used?
What is cold weather oil to be used? At what air temperature?
Where should oil level sit?
When should you add oil?
What is capacity?
20 minutes
Mobil jet 254
MIL-PRF23699
MIL-PRF-7808 (-25C or below)
Top set of bolts
Less than halfway between add line and full line
7.3 quarts
MGB: when do you check oil level after shutdown? Cold and Hot?
What is primary oil used?
What is secondary oil to be used?
What is cold weather oil to be used? What is air temperature?
What is capacity?
Hot side: 1/2 to 2 hrs after shutdown
Cold side: more than 2 hours after shutdown.
DOD-PRF-85734
No secondary oil
MIL-PRF-7808 (OAT -40C to -55C)
7.5 gallons
IGB: primary oil used?
Secondary oil used?
Cold weather oil used? At what air temperature?
Capacity?
Replace when needs how much oil?
DOD-PRF-85734
No secondary oil
MIL-PRF-7808 (-40C to -55C)
2.75 pints
300 ml
TGB: primary oil used?
Secondary oil used?
Cold weather oil used? What is air temperature?
Capacity?
Replace when needs how much oil?
Dod-prf-85734
No secondary oil
MIL-PRF-7808 (-40C to -55C)
2.75 pints
400 ml
Viscous bearing: primary oil used?
Servicing: 0-1 in?
1-2 in?
2+ in?
Vv-d-1078
0-1 in: no correction
1-2 in: requires service
2+ in: requires replacement
Hydraulic system: how long after shutdown do you check oil level?
Piston movement of how long into overfill zone is acceptable?
What is max over temp indication?
1 hr
3/8”
270 degrees F
Cargo loading: floor is rated at how many lbs per sq ft?
Cabin deck rings are rated at how many lbs?
Where should cargo be loaded, ideally?
300 lbs per sq ft
2,500 lbs
Under MGB if possible
Passenger vest MD-1127 V22: what is buoyancy?
What is inventory?
35 lbs of buoyancy
Strobe light Mirror Whistle Has oral inflation tube Automatic inflation
LPU-27/PE SAR warrior: what is buoyancy?
What is in left middle pocket?
65 lbs buoyancy
Seas-1 bottle 3000 psi
LPU 27: what is in left upper pocket?
What is in left front pocket:
Upper: flashlight
Front: MK-124
LPU-27: what is in right upper pocket?
Right middle pocket?
Upper: survival knife
Middle: 406 PLB (121.5 and 406 MHz)
Sea pack and charms
LPU-27: what is in right front pocket?
Front: shroud cutter with 3 beads Strobe light MK-79 kit Signal mirror Whistle
Flir: do not range an object closer than how many meters?
What class is the laser rangefinder?
50 meters
Class 1
Flir: what class is the laser illuminate?
Class 4. It is prohibited.
Flir: how long does it take for IR to cool down?
6-8 minutes. CHOT will be displayed.
No longer than 15 min
Flir: what is ground clearance from the turret?
1’5”
Flir: what is the ground clearance without the turret and trakkabeam?
2’5”
Trakkabeam: initialization should be done under what speed?
40 kias
Trakkabeam: do not expose people to the light within how many feet?
250 ft
Trakkabeam: max airspeed while positioning?
140 kias
Trakkabeam: what is ground clearance in stowed position?
1’1”
Trakkabeam: what is ground clearance when it is straight down?
8”
Trakkabeam: Do not switch system power off until lamp cooling fan has automatically stopped. How long will the fan run for after lamp is turned off?
2 min
What are the dimensions of the cabin door opening?
54 in high and 44 in wide
What oil is the hoist serviced with?
What is capacity?
MIL-PRF-23699
1100ml
What is the primary oil for the engine starter?
Secondary oil to be used?
Mobil Jet 24
MIL-PRF-23699
What is the play limits for the stab wings?
7/16”
How many filters on Trakkabeam and what are they?
- White
- IR
- IR
- IR
- Amber
- White
Distance against flammable liquids for Trakkabeam?
10 ft
Trakkabeam: the white light should not be operated below how many feet above ground/water level?
50 ft
What is max allowable deflection for tip caps?
12 in
What manual do you find the passenger brief card?
CGTO 1h-60t rnp-1 flight manual
When is an operational check of the cabin emergency lighting done?
First pre-flight of the day
Redundant links can be found on which two boost assemblies?
Yaw and collective
What is the total number of flame detectors on the aircraft?
5
2 on each engine
1 on APU
To jettison the cabin window emergency exit, you must grab window hand strap, pull tab to remove seal, and finally?
Pull window in.
During rotor engagement , where should the fireguard be positioned?
Safety zone A or B
What should be requested when fueling at a civilian airport?
Prist with the fuel
During the hydraulic leak test, aircrew members shall be ? At a minimum.
In the cabin maintaining a firm handhold
The 406 PLB transmits on what frequency?
121.5 MHz
To prevent damage to the MRB’s, do not deflect the MRB tip more than ? inches.
12 inches
Which system is used as a backup to provide attitude, air data, and heading information?
ESIS
Where is the handle located to move the crew seat up or down?
Under the seat pan on the right of each seat
How many cameras are on the TSU and what are they?
3
IR
CCD-color
EMCCD-low light conditions
What is the hourly fuel consumption of the 60?
1000 pounds
How much does Jet fuel weigh?
150 gallons = 1000 pounds
6.7 per gallon
What is proper response for Trakkabeam prior to landing?
Stowed
What is proper response for Trakkabeam on deck?
Off
What is the fuel transfer rate?
250-300 lb per minute
In AUTO, when does fuel transfer initiate and what is there sequence?
Main fuel tanks drop below 68% (about 2,600 lbs)
Transfer sequence is RINBD, LINB, LOUTB.
What is the fuel dump rate?
About 800 lbs per min
How much fuel is left in each main tank when the dump valves automatically shutoff?
270 lbs in left main tank
210 lbs in right main tank
When does centrifugal force pull the antiflaps out to permit flapping of the blades?
Main rotor is spinning above 35% Nr
When does centrifugal force pull the droop stops out to permit increase vertical movement of blades?
Main rotor is rotating between 55 and 60% Nr
What psi does the hoist priority valve open?
2500 psi
What is the cargo hook rated for?
6000 lbs
When fueling aircraft, what is minimum distance from other aircraft and structures?
50 ft
When fueling aircraft, what is minimum distance from operating ground or radar set?
300 feet
When fueling aircraft, what is minimum distance from smoking or setting any flame?
50 feet
The laser illuminate is class 4 laser at what distance?
918 yards with 12x binoculars and 67 yards unaided
What are the 3 SAR modes in the ESS?
Small
Medium
Large
Trakkabeam: which light should not be used in fog or low-cloud conditions?
White/clear
Trakkabeam: what must be done first to initiate use of the trakkabeam from the stowed position?
It needs to be deployed
On the lpcaps, what does the top row consist of?
- V1 (arc-210)
- V2 (arc-210)
- H3 (arc-220) HF ALE
- F4 (rt-5000)
- F5 (rt-5000 SAR)
- DF audio
- ICS independent volume control
On the lpcaps, what does the bottom row consist of?
- VOR/ILS
- TACAN
- LF/ADF
- Marker beacon and copilot altitude warning system
The no1 hydraulic system powers what?
First stage primary Servos and first stage tail rotor servo.
If pump failure, backup pump supples power to first stage servos and first stage tail rotor servo.
The no2 hydraulic system powers what?
Second stage primary servos and pilot assist servos.
If pump failure, backup pump provides power for second stage main servos.
What components does the utility module connect to?
No1 and no2 transfer modules
Second stage tail rotor servo
Rescue hoist
APU accumulator