B744 ECS PANEL Flashcards

1
Q

What happens to the Outflow Valves upon Touchdown?

A

They go full open

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
2
Q

If one Outflow Valve is in MAN, will the other Outflow Valve operate in AUTO?

A

YES

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
3
Q

Where/When can I observe Cabin Alt & Rate, Landing Alt?

A
Primary EICAS Display when:
- Landing Alt in Manual
- Cabin Alt in Caution or Warning
- Cabin Differential Press in Caution or Warning 
ECS or ENG selected on Secondary EICAS
How well did you know this?
1
Not at all
2
3
4
5
Perfectly
4
Q

Is there auto switching of Cabin Altitude controllers if one should fail?

A

YES

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
5
Q

When does the Cabin ALT warning siren sound?

A

Cabin Altitude excessive (>10,000’)

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
6
Q

What is the max allowable cabin differential pressure for T/O & Landing?

A

.11 psi

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
7
Q

What is the max differential pressure (relief valves)?

A

9.4 psi

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
8
Q

How many positive pressure relief valves are there and where are they located?

A

2

E and E compartment, left front compartment

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
9
Q

Where are the negative pressure relief valves located?

A

Cargo doors (side, fwd & aft)

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
10
Q

What is the Temp° range for the Flt Deck?

A

18°-29°C (65°-85°F)

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
11
Q

What does the Manual position of the Temp° controllers do?

A

Sets the Trim air valves manually

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
12
Q

What will cause a Zone Sys Fault light to illuminate?

A
Ø Temp° Zone duct overheat 
Ø Zone Temp° Controller fault 
Ø Master Trim air valve closed 
Ø Trim air switch OFF
Ø Master Trim air valve closed and pack air still flowing
How well did you know this?
1
Not at all
2
3
4
5
Perfectly
13
Q

What will cause a Pack Sys Fault light to illuminate?

A
  • Pack Overheat or other Sys fault

- May illuminate briefly while switching between controller (Auto or Manual)

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
14
Q

What happens when I press the Trim Air switch to OFF?

A

Ø Master Trim Air valve closes
Ø Pack output temp° in backup mode (18°-29°C) as selected by Flt Deck selector in AUTO
Ø No control of Flt Deck, Upper Deck or main Deck
Ø Pack controller A only

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
15
Q

On the ground, engines not running, where is Equip Cooling exhaust air routed?

A

Into the Lower Fwd Cargo compartment when temp° < 7°C

Overboard when temp° > 7°C

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
16
Q

What happens to the Equip Cooling system on the grd when engines are running?

A

Configures for Flt closing the outboard exhaust valve, venting air into the Lower Fwd Cargo compartment

17
Q

What does the STBY position of the Equip Cooling system do?

A

Manually reconfigures the aircraft for flight doing the same as above

18
Q

What does the OVRD position of the Equip Cooling system do?

A

The fans are deactivated and the air is vented overboard using cabin differential pressure

19
Q

What items are provided air from the center Duct?

A
Ø Master Trim Air 
Ø Aft Cargo heat
Ø Cargo Smoke detection
Ø Potable Water pressurization
Ø Lower Lobe Cargo air conditioning Trim Air