Avionics Flashcards

1
Q
  1. The standby HSI receives its heading data from:
A

B. AHRS 2

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
2
Q
  1. In order to fully function, the autopilot and yaw damper both require:
A

B. Two valid AHRS without attitude miscompares

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
3
Q
  1. Your PFD shows red flags of lAS, ALT, and
    VS. Which reversion control should you use?
A

B. DADC REV

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
4
Q
    1. Without normal aircraft DC power, the standby flight display battery should last:
A

D. 88 minutes

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
5
Q
  1. Normally needed FMS data entry items are indicated by:
A

A. Boxes

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
6
Q
  1. Localizer-based approaches may be flown from the FAF to the runway using the Col-lins FMS as the lateral navigation source.
A

B. False

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
7
Q
  1. If any data (other than messages) appear in yellow on any FMS CDU page:
A

A. Some parameter is in error

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
8
Q
  1. In order for the left PFDs NAV source to au-toswap from FMS to LOC:
A

D. All the above

A. A localizer-based approach must be entered into the FMS
B. The aircraft must be within 30 nm of that airport
C. Either APPR or B/C on the mode select panel must be pushed

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
9
Q
  1. To enter airways into the flight plan:
A

D. Both B and C

B. The waypoints where you get on and off the airway must be on the FLN page

C. The airway designator can only be entered under the VIA column on the FPLN page, on the line immediately after the waypoint where you get on the airway

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
10
Q
  1. GPS approaches flown to an MDA usually use which mode select buttons?
A

B. NAV and VNAV

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
11
Q
  1. To move the controlling FGC arrow from the left side to the right side:
A

C. Press the AP XFR button on the autopilot panel and reprogram the flight director

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
12
Q
  1. The FMS TUN page can be used to control
    ATC modes, TCAS test, and marker beacon sensitivity.
A

B. False

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
13
Q

For VNAV to fly a descent path, the Collins FMS must be the active NAV source and:

A

D. All the above

A. An altitude constraint at a waypoint must be entered on the LEGS page

B. VNAV must be on

C. The altitude preselector must be lowered below the current cruising altitude (normally to the altitude cleared to by ATC)

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
14
Q
  1. A type 6 FMS is currently authorized for use to fly to which minima?
A

D. Both A and B

A. LNAV (MDA)
B. LNAV/VNAV (DA)

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
15
Q
  1. The Collins FMS and the Garmin GPS receiver communicate with each other in all aspects.
A

D. Never

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
16
Q

The left PFD is displaying a PPOS map from
FMS 1. Which statement is correct?

A

C. A PLAN map can be displayed on the
MFD, but only after the left PFD is not displaying the PPOS map.

17
Q
  1. The IFIS panel displays charts and graphic weather on the:
A

D. MFD only

18
Q
  1. Both PFDs and the MFD must be fully operational without any reversions prior to dispatch.
19
Q
  1. The CE-525 is certified for Cat I| ILS operations.
20
Q
  1. The radar altimeter is tested:
A

C. When the rotary test knob is in the ANNU position

21
Q
  1. A type 7 FMS may fly to LPV minima provided:
A

D. Both A and B