Autoflight Flashcards
While the auto pilot is engaged, The use of aileron trim is
Prohibited
The AFDS is a dual system consisting of how many individual FCC‘s and a single mode control panel
Two
All AFDS modes can be disengaged when you select another command mode or
By disengaging the AP and turning the FD’s off
Auto pilot engagement in CMD or CWS is inhibited unless
- No force is being applied to the control wheel
- The stab trim auto pilot cut out switch is at normal
When you are in a single AP operation full automatic flair and touchdown capability and AP go around capability are
Not available
What steering command allows both of the APs to be engaged at the same time
Approach mode
The AP automatically disengages when
- activating either pilots control wheel trim switch or loss of respective hydraulic system pressure
- Pushing either AP disengage switch or pushing either TOGA switch with a single AP engaged in CWS or CMD below 2000 feet RA
On the 737 the FD’s can be operated
With or without the AP and AT
How do you know which FCC is the master
By illumination of the respective master (MA)FD indicator light
What following indications are displayed in the AP status display located above the attitude indicator
- CMD, FD, 1CH
- CWSP, CWSR
What does CMD indicate in the auto pilot status display of the AFDS
One or both auto pilots are engaged
What does CWS P indicate in the auto pilot status display of the AFDS
Pitch mode engaged in CWS
What does CWSR indicate in the auto pilot status display of the AFDS
Roll mode engaged in CWS
What does single CH indicate in the auto pilot status display of the AFDS
For a single AP ILS approach annunciates after localizer capture and remains on for entire approach
What does in one indicate on the AFDS flight mode annunciations autothrottle mode
The auto throttle maintains thrust at the selected N1 limit displayed on the thrust mode display, including full go around N1 setting
What does GA indicate on the AFDS flight mode annunciations autothrottle mode
The autothrottle maintains thrust at reduced go around setting
What does FMC SPD indicate on the AFDS flight mode annunciations auto throttle mode
The autothrottle maintains speed commanded by the FMC. The autothrottle is limited to the N1 value shown on the thrust mode display
What does MCP SPD indicate on the AFDS flight mode annunciation autothrottle mode
The autothrottle maintained speed set in the MCP IAS/MACH display. The autothrottle is limited to the N1 value shown on the thrust mode display
What does THR HLD indicate on the AFDS flight mode annunciations auto throttle mode
The thrust lever autothrottle servos are inhibited. The Pilot concert the thrust levers manually