ATP Paper FP4

Question 1

What does a green LED indicate when it is constantly illuminated on the ATP Speedo?

Answer 1

C. The maximum speed of the train at that point.

Question 2

What does a flashing green LED indicate on the ATP Speedo?

Answer 2

D. It indicates a target speed ahead.

Question 3

What does a yellow LED indicate when illuminated on the ATP Speedo?

Answer 3

D. It indicates a release speed for that signal.

Question 4

What is the speed range of the yellow LED’s on the ATP Speedo?

Answer 4

A. 0 to 50 mph

Question 5

What indications would you expect to see in the display window if running under green signals?

Answer 5

B. ===

Question 6

After passing over a beacon at a signal displaying a double yellow, what indication would you expect to see in the ATP display window?

Answer 6

C. .00

Question 7

After passing over a beacon at a signal displaying a single yellow aspect, what indication would you expect to see in the ATP window?

Answer 7

A. 000

Question 8

You have passed a signal displaying a double yellow, you are approaching the single yellow when it clears to a double yellow. What ATP indication would you receive if your train then passes over the infill beacon or loop?

Answer 8

A. The displaying would change from .00 to ===

Question 9

How many buttons are there at the base of the ATP drivers display panel?

Answer 9

C. 4

Question 10

What are the buttons at the bottom of the ATP display panel?

Answer 10

A. ON
E. SHUNT
F. BRAKES
H. PASS STOP SIGNAL

Question 11

At what speed above which is permitted will ATP give you an audible warning?

Answer 11

D. 3mph

Question 12

At what speed above that which is permitted will ATP intervention occur?

Answer 12

A. 6mph

Question 13

If when braking, ATP gives a warning what action would the driver need to take?

Answer 13

B. Increase the braking until warning ceases

Question 14

When it is safe to do so, how would a driver come out of intervention?

Answer 14

C. By pressing the brakes button when it flashes ensuring the brakes only release to a level required by the current situation

Question 15

If when stopped at a signal the associated position light clears what actions should the driver take?

Answer 15

D. You may proceed normally according to the signalling conditions ahead

Question 16

What indications would be in the ATP window display once you pass a cleared position light associated with a signal?

Answer 16

C. PLS

Question 17

How would you put ATP into temporary isolation?

Answer 17

B. Press the ON button for 10 seconds or until ISO displayed

Question 18

What is a level 1 fault?

Answer 18

C. It is a wrong-side failure

Question 19

How do you come out of temporary isolation?

Answer 19

A. Press the ON button briefly and reconfirm data

Question 20

What is a level 3 fault?

Answer 20

C. It is a right-side failure. It displays EXX in the display window

Question 21

When should you report level 1 fault?

Answer 21

A. Immediately, stopping specifically to do so